Operating Instructions
VACUUM CLEANER
❈
Before operating this unit, please read the instructions carefully.
❈ Indoor use only.
Register your product at www.samsung.com/global/register
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do not
allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run
unattended at any time. Use the vacuum cleaner only for its intended use as described in
these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in
order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the
vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour
the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not
block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from the
electrical outlet. Disconnect the plug from the electrical outlet before changing the dust
bag or dust container. To avoid damage, please remove the plug by grasping the plug
itself, not by pulling on the cord.
8. This appliance is not intended for use by young persons or infirm persons without
supervision unless they are adequately supervised by a responsible person to ensure that
they can use the appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
9. The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult
an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
13. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
1
ASSEMBLING THE CLEANER
1
OPTION
Features may vary according to model.
▼
2
CAUTION
Please do not press the button of
dust bin handle when carrying
machine.
For storage, park the floor nozzle.
OPERATING THE CLEANER
2
2-1 ON/OFF SWITCH
1) BODY CONTROL TYPE 2) ON/OFF TYPE
2-2 POWER CORD
NOTE
When removing the
plug from the
electrical outlet, grasp the
plug, not the cord.
2-3 POWER-CONTROL
1) SILDE CONTROL TYPE ONLY (Optional)
• SLIDE TO THE STOP POSITION
Vacuum-cleaner switches off (stand by mode)
• SLIDE FORWARD TO MAX
Suction capacity increases smoothly up to maximum.
2) BODY-CONTROL TYPE / ON/OFF TYPE
- HOSE - BODY (BODY-CONTROL TYPE ONLY)
To reduce suction for cleaning draperies,
small rugs, and other light fabrics, pull the
tap air until the hole is open.
MIN = For delicate surface e.g. net curtains.
MAX = For hard floors and heavily soiled carpets.
3
2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
▼
PIPE
ACCESSORY
OPTION
Adjust the length of the telescopic
pipe by sliding the length control
button located in the center of the
telescopic pipe back and forth.
Carpet
Cleaning
To check for blockages, separate
the telescopic pipe and adjust to
shorten. This allows for easier
removal of waste clogging the tube.
Push the accessory on to
the end of the hose handle.
Pull out and turn the dusting brush for cleaning delicate areas.
To use the upholstery tool,
push the accessory on to
the end of the hose handle
in the opposite direction.
Floor
Cleaning
Adjust the inlet lever according to the
floor surface.
4
Remove waste matter completely if the
inlet is blocked.
OPTION
- Detach transparent drum cover for easy cleaning.
OPTION
Brush for blanket
For picking up pet
hair and fibre on
upholstery and bed
linen.
OPTION
Clogs on turbine keep brush from turning, thus need to be unclogged as follows.
Turbine
Remove waste
matter completely when
inlet is blocked.
Warning : Use for bedclothes only. Be cautious not to damage brush
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
Turn the lock button to
‘UNLOCK’, and remove
waste matter.
during unclogging.
Brush
To reassemble, align the cover to
the front of the main body and
close. After closing the cover,
ensure that the lock button is
turned to the ‘LOCK’ position.
1 2 3
Remove waste matter
Push the Open button of
the transparent screen
cover to separate the cover.
4
Remove the brushbar
from the transparent
screen.
5
such as dust and hair
tangled around the
brushbar using scissors.
6
For improved pick-
up of pet hair and
fibre on carpets
Remove dust inside the
brush housing using a
dry duster or crevice tool.
Insert brushbar into
rotating belt and
assemble.
5
Click the transparent
screen cover back into
place to reassemble.
CLICK
EMPTYING THE DUST BIN
3
1 2 3
Option
Once dust reaches the dust full
mark, or once the dust
full light is on, empty the dust bin.
4 5
Throw away dust into
the bin.
- Empty into a plastic bag
(recommended for asthma/allergy sufferers)
Close the dust bin cover.
Take the dust bin out by
pressing the button.
6
Before use, push the dust bin
into the main body of the vacuum cleaner until you hear
the "click" sound.
Separate the dust
bin cover.
NOTE
You may rinse the dust bin with cold water
6
CLEANING THE DUST PACK
4
4-1. WHEN TO CLEAN THE DUST PACK
- If suction is noticeably reduced during cleaning, please check the dust pack as indicated
below.
Suction is significantly weakened during cleaning.
Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.
Turn the vacuum power to 'MAX'
HANDLE CONTROL
If the filter check indicator turns red
with the inlet floating 10 cm above
flat floor, clean it.
When the indicator light comes
on, please empty the Dust
Pack(4-2) as shown in the following illustrations.
7
4-2 CLEANING THE DUST PACK
12
Remove the dust bin and dust
pack as shown.
Remove the fixed frame
of the dust pack cover.
4
Wash the sponge and the filter
of the dust pack with water.
Let the sponge and filter dry
in the shade for more than
12 hours.
7 8
3
Remove the sponge and filter
from the dust pack.
65
Put the sponge and filter
into the dust pack.
Before reassembly,
align the dust pack cover
and dust pack correctly.
NOTE :
Make sure the filter is completely dry before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
Put the assembled dust pack
into the main body.
8
CLEANING THE MOTOR PROTECTION FILTER
5
Remove the motor protection filter from
Take out both the dust bin and the
dust pack.
CLEANING THE OUTLET FILTER
6
the vacuum cleaner.
Shake and tap the dust from it and put
back in machine.
Press the fixed frame
part at the back of the
main body to remove.
OPTION - MICRO CARBON FILTER
Remove and replace the blocked outlet filter.
Pull out the HEPA Filter
using the tab.
Dust the HEPA filter. Put the HEPA filter into
NOTE :
9
the main body until you
hear a ‘click’ sound.
Replacement filters
are available at your
local Samsung distributor.
- IF YOU HAVE A PROBLEM
PROBLEM CAUSE REMEDY 0
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind fully. Check that the cord is not
No power supply.
Thermal cut-out.
Nozzle, suction hose or tube
is blocked.
twisted or wound unevenly.
Check cable, plug and socket.
Leave to cool.
Check for blockage and
remove it.
Pull the cord out 2-3m and
push the cord rewind button.
Vacuum cleaner does not
pick up dirt.
Low or decreasing suction
Crack or hole in hose.
Filter is full of dust.
Check hose and replace if
required.
Please check filter and, if
necessary, clean as illustrated in the instructions.
10
If you have any comments or questions regarding Samsung products,
contact the SAMSUNG customer care center.
Country
AUSTRALIA
HONG KONG
MALAYSIA
SINGAPORE
Customer Care Center ☎
1300 362 603
3698-4698
1800-88-9999
1800-SAMSUNG (7267864)
Web Site
www.samsung.com
www.samsung.com/hk
www.samsung.com/my
www.samsung.com
DJ68-00339U REV(0.2)
Loading...