5 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the SyncMaster 320TFT/520TFT monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components.
5-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
5-1-1 Removing the Stand
1.Remove 2 hinge caps on the Rear Cover.
2.Remove 4 screws in the hinge area.
Figure 5-1
3.Push the Stand to the left and remove the Stand from Body (Front).
4.Remove the Cover Signal.
5-1-2 Front Cover Disassembly
Figure 5-3
1. Remove the 4 screws on Rear Cover. (Point ; )
2.Remove Rear Cover from Front Cover.
3.Remove 6 Main PCB screws on Rear Panel Bracket. (Point ; )
4.Disconnect Main PCB, Inverter wire, Function wire and Interface wire.
5.Remove Main PCB Assembly.
Figure 5-2
5. Disconnect Power Cord and Signal Cable.
SyncMaster 320TFT/520TFT |
5-1 |
5 Disassembly and Reassembly
Figure 5-4
6.Remove 4 screws on the Rear Panel Bracket. (15” : 6 screws)- Point;
7.Remove Bracket Panel from Front Cover.
8. |
Remove 1 screw on the |
PCB. (Point; |
|
) |
|
||||
9. |
Remove Function PCB |
locking area of |
||
|
Function Knob. |
|
|
|
Figure
10.Remove 4 screws on the Front Bracket Panel.
11.Remove Front Bracket Panel.
12.Disconnect jack between Panel and Inverter PCB.
13.Remove Rear Bracket Panel.
Figure 5-6
14.Remove 2 connecting screws between Rear
15.Remove Interface wire on the Rear side of Panel.
5-1-3 Stand Disassembly
1.Stand the stand assembly with the base close to you.
Figure 5-7
2.Remove the 4 screws on the back cover of the stand and remove it.
3.Stand the stand assembly upside down.
5-2 |
SyncMaster 320TFT/520TFT |