Samsung LTN-140AT16-2 Datasheet

TO
DATE
SAMSUNG TFT-LCD
: January. 7, 2011
MODEL NO. : LTN140AT16
NOTE : Extension code [ -2 ]
www.jxlcd.com
www.jxlcd.com
LTN140AT16-2
Surface type [ Anti glare ]
Any Modification of Spec is not allowed without SEC’ permission.
APPROVED BY :
PREPARED BY : Application engineering group, TCS team
Technical Customer Support Team, LCD Division
Samsung Electronics Co., Ltd.
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
Page
/ 26LTN140AT16-2
1
CONTENTS
Revision History General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
3.3 LED Driver
4. Block Diagram
4.1 TFT LCD Module
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Timing Diagrams of LVDS For Transmitting
5.4 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.5 Pixel format
www.jxlcd.com
www.jxlcd.com
5.6 LED Driver Connector & Pin Assignment
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 4 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 7 )
- - - - - - - - - - - - - - - - - - - ( 10 )
- - - - - - - - - - - - - - - - - - - ( 13 )
- - - - - - - - - - - - - - - - - - - ( 14 )
6. Interface Timing
6.1 Timing Parameters
6.2 Timing Diagrams of interface Signal
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. Packing
9. Markings & Others
10. General Precautions
Samsung Secret
- - - - - - - - - - - - - - - - - - - ( 19 )
- - - - - - - - - - - - - - - - - - - ( 21 )
-- - - - - - - - - - - - - - - - - - ( 21 )
-- - - - - - - - - - - - - - - - - - ( 23 )
-- - - - - - - - - - - - - - - - - - ( 25 )
Doc.No. Rev.No
04-A00-S-110107
Page
/ 26LTN140AT16-2
2
REVISION HISTORY
Date Revision No. Page
May. 31. 2010 P00 All The specification of LTN140AT16-2 model was issued first.
Summary
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
Page
/ 26LTN140AT16-2
3
GENERAL DESCRIPTION
DESCRIPTION
LTN140AT16 is a color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as switching devices. This model is composed of a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 14.0" contains 1366 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the optimum
viewing angle.
FEATURES
High contrast ratio
HD (1366 x 768 pixels ) resolution
Low power consumption
Fast response time
LED Back Light with embedded LED Driver
DE (Data enable) only mode
3.3V LVDS Interface
Onboard EEDID chip
Green product (RoHS compliant)
APPLICATIONS
Notebook PC
If the usage of this product is not for PC application, but for others, please contact SEC
www.jxlcd.com
GENERAL INFORMATION
Display area Driver element Display colors Number of pixel Pixel arrangement Pixel pitch Display Mode
www.jxlcd.com
Item Specification Unit Note
309.399(H) x 173.952(V) ( 14.0” HD diagonal ) mm
a-Si TFT active matrix
262,144
1366 x 768 pixel 16:9
RGB vertical stripe
0.2265(H) x 0.2265(V) (TYP.) mm
Normally white
Surface treatment
Samsung Secret
Doc.No. Rev.No
Haze (25)%, Hard-Coating 3H
04-A00-S-110107
Page
/ 26LTN140AT16-2
4
Mechanical Information
Item Min. Typ. Max. Unit Note
Horizontal (H) 323.0 323.5 324.0 mm
Module
size
Note (1) Measurement condition of outline dimension
Vertical (V) 191.5 192.0 192.5 mm
Depth (D) - - 5.2 mm (1)
Weight - 330 350 g
. Equipment : Bernier Calipers . Push Force : 500g f (minimum)
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
Item Symbol Min. Max. Unit Note
Storage temperate TSTG -20 60 C (1)
Operating temperate
(Temperature of glass surface)
Shock ( non-operating ) Snop - 240 G (2),(4)
Vibration (non-operating) Vnop - 2.41 G (3),(4)
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. (40 C Ta)
www.jxlcd.com
www.jxlcd.com
Maximum wet - bulb temperature at 39 OC or less. (Ta 40 C ) No condensation
100
90
80
60
40
20
0
-40 -20 0 20 40 60 80
TOPR 0 50 C (1)
Relative Humidity ( %RH)
( 40,90 )
Operating Range
Storage Range
5
( 50,50.4 )
( 60,27.7 )
Temperature (OC)
(2) 2ms, half sine wave, one time for X, Y, Z. (3) 5 - 500 Hz, random vibration, 30min for X, Y, Z. (4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
Page
/ 26LTN140AT16-2
5
1.2 ELECTRICAL ABSOLUTE RATINGS (1) TFT LCD MODULE
Item Symbol Min. Max. Unit Note
Power Supply Voltage VDD VDD - 0.3 VDD + 0.3 V (1)
Logic Input Voltage VIN VDD - 0.3 VDD + 0.3 V (1)
Note (1) Within Ta (25 2 C )
VDD =3.3V, VSS = GND = 0V
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
Page
/ 26LTN140AT16-2
6
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics should be measured in a dark room or equivalent state with the methods shown in Note (5). Measuring equipment : TOPCON SR-3
* Ta = 25 2 C, VDD=3.3V, fv= 60Hz, fDCLK = 72.33MHz, IF = 24.5 mA
Item Symbol Condition Min. Typ. Max Unit Note
Contrast Ratio
(5 Points)
Response Time at Ta
( Rising + Falling )
Average Luminance of White (5 Points)
Red
Color
Chromaticity
( CIE )
Green
www.jxlcd.com
Blue
www.jxlcd.com
White
CR
TRT - 8 16 msec (1), (3)
YL,AVE 170 200 - cd/m
RX 0.550 0.580 0.610 RY 0.310 0.340 0.370 GX 0.305 0.335 0.365 GY 0.520 0.550 0.580 BX 0.120 0.150 0.180
BY 0.055 0.085 0.115 WX 0.283 0.313 0.343 WY 0.299 0.329 0.359
Normal
Viewing
Angle
= 0= 0
300 - - - (1), (2), (5)
IF=24.5mA
2
(1), (4)
-
(1), (5)
SR-3
Color Gamut 42 45 - %
L
Hor.
Viewing
Angle
13 Points
White Variation
Samsung Secret
Ver.
Hor.
Ver.
H
H
L
L
R
H
L
L
CR 10
At center
CR 100
Doc.No. Rev.No
40 - ­40 - ­15 - ­30 - ­25 - ­25 - -
5 - -
15 - -
- - 1.54 - (6)
04-A00-S-110107
Degrees
(1), (5)
Degrees
Page
SR-3
7
/ 26LTN140AT16-2
Note 1) Definition of Viewing Angle : Viewing angle range(10 C/R)
Normal Line
o
= 0
L
L
L
=90
o
x
H
,
= 0
o
R
12 O’clock
direction
y
H
= 90
o
6 O’clock
direction
o
= 90
L
Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)
at 5 points(4, 5, 7, 9, 10)
CR(4) + CR(5) + CR(7) + CR(9) + CR(10)
CR =
Points : , , , , at the figure of Note (6).
Note 3) Definition of Response time :
Display data
www.jxlcd.com
www.jxlcd.com
Optical Response
4 9
100%
90%
10%
0%
5
White(TFT OFF) White(TFT OFF)
7
5
10
Black(TFT ON)
TR
x'y'
=90
R
TF
o
Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.
342 683 1024
Average Luminance of White ( YL,AVE )
YL4 + YL5 + YL7 + YL9 + YL10
YL,AVE =
5
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
10
9
7
5
4
: test point
Time
VIEW AREA 192
384
576
(lines)
Page
/ 26LTN140AT16-2
8
Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement
should be executed. Measurement should be executed in a stable, windless,and dark room. 30 min after lighting the backlight. This should be measured in the center of screen. IF current : 20.0mA Environment condition : Ta = 25 2 C
Photo-detector
( TOPCON SR-3 )
Field = 2
50 cm
TFT-LCD module
Center of the screen
[ Optical characteristics measurement setup ]
www.jxlcd.com
www.jxlcd.com
Note 6) Definition of 13 points white variation (L ), CR variation( CVER ) [ ~ ]
Maximum luminance of 13 points
L =
Minimum luminance of 13 points
LCD panel
1 13
Samsung Secret
Doc.No. Rev.No
04-A00-S-110107
: test point
Page
/ 26LTN140AT16-2
9
Loading...
+ 18 hidden pages