A-PDF Watermark DEMO: Purchase from www.A-PDF.com to remove the watermark
Approval
TO
DATE
SAMSUNG TFT-LCD
: Apple / Quanta
: Oct. 27, 2008.
MODEL NO. : LTN133AT09-R02
NOTE :
NOTE :
www.jxlcd.com
www.jxlcd.com
- Extension code [ -R ] ; LTN133AT09-R02
- Surface type [ Glare ]
APPROVED BY :
PREPARED BY : Application Engineering Part , Mobile LCD Division
SAMSUNG ELECTRONICS CO., LTD.
Samsung Secret
Doc.No.Rev.No
04-A00-S-081027
Page
/ 25LTN133AT09-R02
1
CONTENTS
Approval
Revision History
General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
3.3 LED Array
3.4 LED information
4. Block Diagram
4.1 TFT LCD Module
4.2 Backlight Unit
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
www.jxlcd.com
www.jxlcd.com
5.3 Backlight Unit
5.4 Timing Diagrams of LVDS For Transmitting
5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.6 Pixel format
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 4 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 7 )
- - - - - - - - - - - - - - - - - - - ( 11 )
- - - - - - - - - - - - - - - - - - - ( 14 )
- - - - - - - - - - - - - - - - - - - ( 15 )
6. Interface Timing
6.1 Timing Parameters
6.2 Timing Diagrams of interface Signal
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. General Precaution
Samsung Secret
Doc.No.Rev.No
- - - - - - - - - - - - - - - - - - - ( 20 )
- - - - - - - - - - - - - - - - - - - ( 22 )
-- - - - - - - - - - - - - - - - - - ( 24 )
04-A00-S-081027
Page
/ 25LTN133AT09-R02
2
REVISION HISTORY
Approval
DateRevision No.Page
Oct. 27, 2008A00AllLTN133AT09-R02 Model spec was approved.
Summary
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No.Rev.No
04-A00-S-081027
Page
/ 25LTN133AT09-R02
3
Approval
GENERAL DESCRIPTION
DESCRIPTION
LTN133AT09-R02 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as a switching devices. This model is composed of
a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 13.3" contains
1,280 x 800 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
• High contrast ratio, high aperture structure
• 1280 x 800 pixels resolution
• Low power consumption
• Fast Response
• W-LED BLU
• DE(Data enable) only mode
• 3.3V LVDS Interface
• Onboard EEDID chip
• RoHS / Halogen free compliance
APPLICATIONS
• Notebook PC
• If the usage of this product is not for PC application, but for others, please contact SEC.
www.jxlcd.com
www.jxlcd.com
GENERAL INFORMATION
ItemSpecificationUnitNote
Display area286.08(H) x 178.80(V) (13.3” diagonal )
Driver elementa-Si TFT active matrix
Display colors262,144
Number of pixel1280 x RGB(3) x 800
Pixel arrangementRGB vertical stripe
Pixel pitch0.2235(H) x 0.2235(V) (TYP.)
mm
pixel16 : 10
mm113.6DPI
Display ModeNormally white
Surface treatmentHaze 0, Hard-Coating 3H
Samsung Secret
Doc.No.Rev.No
04-A00-S-081027
Page
LT4
4
/ 25LTN133AT09-R02
Mechanical Information
ItemMin.Typ.Max.UnitNote
Horizontal (H)296.85297.15297.45mm
Module
size
Vertical (V)191.85192.15192.45mm
Depth (D)-3.33.6mm
Weight-300310g
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
ItemSymbolMin.Max.UnitNote
Storage temperateTSTG-20 60C(1)
Approval
Operating temperate
(Temperature of glass surface)
Shock ( non-operating )Snop-240G(2),(4)
Vibration (non-operating)Vnop-2.41G(3),(4)
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. (40 C Ta)
Maximum wet - bulb temperature at 39 OC or less. (Ta 40 C ) No condensation
www.jxlcd.com
www.jxlcd.com
100
90
80
60
40
20
0
-40-20020406080
TOPR050C(1)
Relative Humidity ( %RH)
( 40,90 )
Operating Range
Storage Range
5
( 50,50.4 )
( 60,27.7 )
Temperature (OC)
(2) 2ms, half sine wave, one time for X, Y, Z.
(3) 5 - 500 Hz, random vibration, 30min for X, Y, Z.
(4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
Note 1) Permanent damage to the device may occur if maximum values are exceeded
Functional operation should be restricted to the conditions described under normal operating conditions.
www.jxlcd.com
www.jxlcd.com
L
L
-25mA(1)
2.83.6V(1)
Samsung Secret
Doc.No.Rev.No
04-A00-S-081027
Page
/ 25LTN133AT09-R02
6
Approval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics
should be measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON SR-3
* Ta = 25 2 C, VDD=3.3V, fv= 60Hz, fDCLK = 72.5MHz, IL = 19.0 mArms