Samsung LE32S86BD 07 Alignment & Adjustment

3 Alignments and Adjustments

3-1

3 Alignments and Adjustments

3-1 Ser vice Instr uction

1. Usually, a color TV-VCR needs only slight touch-up adjustment upon installation. Check the basic characteristics such as height, horizontal and vertical sync.

2. Use the specified test equipment or its equivalent.

3. Correct impedance matching is essential.

4. Avoid overload. Excessive signal from a sweep generator might overload the front-end of the TV. When inserting signal markers, do not allow the marker generator to distort test result.

5. Connect the TV only to an AC power source with voltage and frequency as specified on the backcover nameplate.

6. Do not attempt to connect or disconnect any wire while the TV is turned on. Make sure that the power cord is disconnected before replacing any parts.

7. To protect aganist shock hazard, use an isolation transform.

3 Alignments and Adjustments

3-2

3-2 How to Access Service Mode

3-2-1 Entering Factory Mode

" "

- If you have Factory remote - control

- The buttons are active in the service mode.

1. Remote - Control Key : Power, Arrow Up, Arrow Down, Arrow Left

Arrow Right, Menu, Enter, Number Key(0~9)

2. Function - Control Key : Power, CH +, CH -, VOL +, VOL -, Menu, TV/VIDEO(Enter)

3-2-2 Panel Check

Specially for LE26,32R7**, You have to check Panel Maker Because of different adjustments as follows. First of all, Check the label rating!

1) Label Rating File

If Panel Mark is "A", Set the factory mode indicating as follows.

Panel BOM(Bill of material) : BN07-00289A Connector between Panel and Power Unit : BN39-00603M (300mm)

* Option Byte

1. Gamma "AUO"

2. Panel Option "AUO"

If Panel Mark is "S" or not printed. Set the factory mode indicating as follows.

Panel BOM(Bill of material) : BN07-00247A Connector between Panel and Power Unit : BN39-00603M (300mm) * Option Byte

1. Gamma "AMLCD"

2. Panel Option "AMLCD_INT" If Panel Mark is "C" , Set the Factory mode indicating as follows. Panel BOM(Bill of Material) : BN07-00207A Connecotor between Panel and Powe Unit : BN39-00659A(200mm) * Option Byte

1. Gamma " CMO "

2. Panel Option " CMO "

Others are same shown below.

PANEL MAKER

Power OFF

PICTURE ON

INFO

DISPLAY

MUTE

FACTORY

Power ON

3 Alignments and Adjustments

3-3

3-3 Factory Data

1. Calibration

2. Option Table XXXX XXXX

3. W/B

4. W/B Movie

5. MTK8202

6. FBE2 option

7. Sound

8. Sound AMP

9. YC Delay

10. Adjust

11. Bus Stop

12. Password 80 80 80 80

13. Checksum 0000

14. Dynamic Contrast

15. Spread Spectrum

16. Reset HDCP Write Success..(or Failure..) T_JSMMPEU-1000 (Main Micom Ver) Month/ Day / Year / Hour/ Min./Sec. T-BRPMNSAS-1000 (Sub Micom Ver. Only BDX Plus) Panel On Time(Hour) XXXXX

1. Calibration

1) AV Calibration

2) DTV Calibration

3) PC Calibration

4) HDMI Calibration

2. Option Byte

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16 17 18 19

item

Panel Inch

Panel Vender

Dimming

Gamma Auto Power Hotel Mode Shop Mode

High Devi

Carrier Mute

TTX

TTX List

TTX Group

TTX ATM

HDMI Select

Volume Table

Sound Wattage

HP Position

Language

HP Detect

CMO 32"

CMO

INTERNAL

Off On Off Off Off Off On

Flof

User OSD

Off

2HDMI

Small

LCD 10W

Side

English

Active High

3 Alignments and Adjustments

3-4

3. White Balance

1 2 3 4 5 6 7 8

»ç¾ç

item

SubBright

Roffset Goffset Boffset

SubContrast

RGain GGain BGain

Low Light

High Light

RF/AV Component

4. W/B Movie

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

item

Service P Mode

Service Color Tone

MSub Brightness

MSub Contrast Warm1 Red Gain Warm1 Blue Gain

Warm1 Red Offset Warm1 Blue Offset

Warm2 Red Gain Warm2 Blue Gain

Warm2 Red Offset Warm2 Blue Offset

Normal Red Gain Normal Blue Gain

Normal Red Offset Normal Blue Offset

Cool2 Red Gain

Cool2 Blue Gain Cool2 Red Offset Cool2 Blue Offset

Mov. Contrast

Mov. Brightness

Mov. Color

Mov. Sharpness

RF/AV/S_video

Dynamic

Cool1

128 128 143 111 128 127 142 101 127 128 134 121 127 126 128 134 128 128

80 50 25 45

3 Alignments and Adjustments

3-5

5. MTK8202

1) Cal. Adjustment

2) Cal. Target

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

item

R_Offset G_Offset B_Offset

R_Gain

G_Gain

B_Gain

Y_Offset

Cb_Offset

Cr_Offset

Y_Gain

Cb_Gain

Cr_Gain

CVBS Offset

CVBS Gain

CVBS U

CVBS V HDMI R_Gain Ref. HDMI G_Gain Ref. HDMI B_Gain Ref.

HDMI R_Offset Ref. HDMI G_Offset Ref. HDMI B_Offset Ref.

2nd Cal Error AV

2nd Cal Error DTV

LVDS Control

value

30 32 23 77 85 89 21 39 41 41 41 41 55 52

0 229 229 229

16 16 16

1 2

item

Black Target

White Target

value

1 235

3) Scart RGB

1 2 3 4 5 6

item

SC1_R_Offset SC1_G_Offset SC1_B_Offset

SC1_R_Gain SC1_G_Gain

SC1_B_Gain

ALL Mode

115 115 115

70 70 70

+ 11 hidden pages