Samsung IFA-E, SRP-350II, SRP-270, SRP-350, IFB-E User Manual

Ethernet user manual

Model

name

Front picture Rear picture

IFA-E

SRP-350

SRP-350II

SRP-270

IFB-E

SRP-370

SRP-372

V3.0.0 www.samsungminiprinters.com

1

1. Hardware

1) Interface version: V3.x.x

2) Difference of IFA-E and IFB-E: All features are same. Only a writing direction of model

name on metal bracket is reverse. It is because of reverse position of the main board of

SRP-350 and SRP-370.

2. Software

1) Configuration program: Configure_V3.xx.exe

- It is to set IP address and communication conditions.

2) Virtual driver (Option): VirtualCOM_V3.xx.exe

- It converts output of Serial (COM) port into output of Ethernet (TCP/IP) port.

- Applicable operating systems: Win 98, 2000, XP, 2003 server

- Contact the sales rep in case you need. It is optional software.

Note: Use the designated tool file described below for the optimal operation according to each

interface version. This version is described on the metal bracket. Each tool file can be

downloaded from website, www.samsungminiprinters.com

Interface

Version

Model

name

Applicable printers Tool file

Network

interface

IFA-E SRP-350, 270, 350II

V 3. x. x

IFB-E SRP-370, 372

Ethernet_V3.x.zip

10/100 Base-T

All in one

V 2. x. x RIF-350E SRP-350, 270 Ethernet_V2.0.zip 10 Base-T

V 1. x. x RIF-350E SRP-350, 270 Ethernet_V1.3.zip 10 Base-T

3. Interface Card specification

1) Network interface: 10/100 Base-T All in one type (auto detection)

2) Protocol: TCP, UDP, IP, ICMP, ARP

3) IP mode: Static IP, DHCP (Dynamic Host Configuration Protocol)

4) RX buffer: 32 KByte

5) Flow control: RTS/CTS (hardware)

V3.0.0 www.samsungminiprinters.com

2

4. Ethernet interface card setup

1) Check the Ethernet interface card version and select the right tool file. V3.x.x is the latest

version.

2) Turn off the printer and install Ethernet interface card.

3) Set a serial communication speed at the highest bps.

- SRP-350: 57,600bps

- SRP-370, 372, 350II: 115,200 bps

- SRP-270: 19,200 bps

4) Connect LAN cable to Ethernet interface card and turn on the printer.

- Use Direct cable (1:1 cable) to connect to HUB(Switch).

- Use Cross cable to connect to LAN card of computer.

5) Run “Configure_V3.xx.exe”.

V3.0.0 www.samsungminiprinters.com

3

6) Select “Search”.

- If you know IP address check in the box of “Direct configuration” and enter IP address.

Then select “search”.

V3.0.0 www.samsungminiprinters.com

4