How it Works
Samsung
Loading...
HT-AS1
User Manual [cz]
26 pgs9.45 Mb0
User Manual
26 pgs9 Mb0
User Manual [hu]
26 pgs9.51 Mb0
Table of contents
Loading...

Samsung HT-AS1 User Manual

Instruction Manual
Digital Amplifier
Speaker System
HT-AS1
HT-AS1T
THIS APPLIANCE IS MANUFACTURED BY:
3
GB
2

Precautions

Ensure that the AC power supply in your house complies with the identification sticker located on the back of your player. Install your player horizontally, on a suitable base (furniture), with enough space around it for ventilation (7.5~10cm). Make sure the ventilation slots are not covered. Do not stack anything on top of the amplifier. In order to disconnect the player completely from the power supply, remove the mains plug from the wall outlet, especially when left unused for a long period of time.
Protect the player from moisture(i.e. vases) , and excess heat(e.g.fireplace) or equipment creating strong magnetic or electric fields (i.e.speakers...). Disconnect the power cable from the AC supply if the player malfunctions. Your player is not intended for industrial use.
Use of this product is for personal use only. Condensation may occur if your player or disc have been
stored in cold temperatures. If transporting the player during the winter, wait approximately
2 hours until the unit has reached room temperature before using.
During thunderstorms, disconnect AC main plug from the wall outlet. Voltage peaks due to lightning could damage the unit.
Do not expose the unit to direct sunlight or other heat sources.
This could lead to overheating and malfunction of the unit.
The battery used with this product contain chemicals that are harmful to the environment. Do not dispose of batteries in the general household trash.
PREP ARATION

Safety Warnings

Wiring the Main Power Supply Plug (UK Only)
IMPORTANT NOTICE
The main lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indicated on the pin face of the plug and if it requires replacing, a fuse approved to BS1362 of the same rating must be used. Never use the plug with the fuse cover removed. If the cover is detachable and a replacement is required, it must be of the same colour as the fuse fitted in the plug. Replacement covers are available from your dealer. If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance. However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do not connect the plug to a main socket as there is a risk of shock hazard from the bared flexible cord. Never attempt to insert bare wires directly into a main socket. A plug and fuse must be used at all times.
IMPORTANT
The wires in the main lead are coloured in accordance with the following code:– BLUE = NEUTRAL BROWN = LIVE As these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as follows:– The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.
WARNING : DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE
LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER (or BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
This symbol indicates “dangerous voltage” inside the product that presents a risk of electric shock or personal injury.
This symbol indicates important instructions accompanying the product.
CLASS 1 LASER PRODUCT
This Compact Disc player is classified as a CLASS 1 LASER product.
Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
CAUTION :
INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS DEFEATED, AVOID EXPOSURE TO BEAM.
WARNING : To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. CAUTION : TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
•
This apparatus shall always be connected to a AC outlet with a protective grounding connection.
•
To disconnect the apparatus from the mains, the plug must be pulled out from the mains socket, therefore the mains plug shall be readily operable.
CAUTION
•
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus.
•
The Mains plug is used as a disconnect device and shall stay readily operable at any time.
CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1
This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
54

Contents

PREPARATION
Safety Warnings..............................................................................................................2
Precautions......................................................................................................................3
Features ..........................................................................................................................4
Description ......................................................................................................................6
CONNECTIONS
Connecting the Speakers................................................................................................10
Connecting External Components ..................................................................................12
OPERATION
Before Using the Digital Amplifier Speaker .....................................................................14
Selecting Digital/Analog Input .........................................................................................16
Setting the Speaker Mode...............................................................................................18
Setting the Speaker Listening Distance .........................................................................20
Setting Digital Input .........................................................................................................22
Setting DRC (Dynamic Range Compression) .................................................................24
Test Tone ........................................................................................................................26
Setting Speaker Level .....................................................................................................30
Dolby Pro Logic ll Mode..................................................................................................32
Dolby Pro Logic ll Effect .................................................................................................34
Setting Tone Control........................................................................................................36
SFE Mode........................................................................................................................38
Stereo Mode....................................................................................................................40
MISCELLANEOUS
Convenient Functions......................................................................................................42
Operating TV with Remote Control..................................................................................44
Operating your DVD (VCR) with Remote Control............................................................46
Before Calling for Service................................................................................................48
Specifications ..................................................................................................................50
PREP ARATION
Dolby Pro Logic II
Dolby Pro Logic II is a new form of multi-channel audio signal decoding technology that improves upon existing Dolby Pro Logic.
DTS (Digital Theater Systems)
DTS play backs 5.1 channel sound with less compression than Dolby Digital for richer sound.

Features

Built-in Subwoofer
Built-in subwoofer in the amplifier enables you to enjoy rich bass sound without additional subwoofer speaker.
Digital Amplifier Speaker
This product is a pure digital Amplifier Speaker that performs digital signal processing to minimize signal distortion and loss.
SFE(Sound Field Effect) Using 24bit Audio DSP
Provides more realistic surround sound with normal stereo audio sources.
GB7GB
6
[
Rear Panel
]

Description

[
Front Panel
]
[
Display
]
SPEAKER INDICATOR
DOLBY PRO
LOGIC II
INDICATOR
DIGITAL INDICATOR
DTS
INDICATOR
LIVE SURROUND
INDICATOR
L.PCM
INDICATOR
DOLBY DIGITAL
INDICATOR
FRONT DISPLAY
DOLBY
INDICATOR
Accessories
√√
œœ
Remote Control User’s Manual
PREP ARATION
POWER button
SELECT ( ) button
,
VOLUME CONTROL
SETUP button
POWER STANDBY Indicator
FUNCTION button
INPUT MODE button
SURROUND MODE button
DVD OPTICAL DIGITAL
AUDIO INPUT JACK
CD COAXIAL DIGITAL
AUDIO INPUT JACK
VCR AUDIO INPUT JACKS
CD AUDIO INPUT JACKS
SUBWOOFER OUTPUT JACKS 1, 2
DVD VIDEO INPUT JACK
MONITOR VIDEO OUTPUT JACK
FRONT SPEAKER TERMINALS
CENTER SPEAKER TERMINALS
SURROUND SPEAKER
TERMINALS
DVD AUDIO INPUT JACKS
VCR AUDIO OUTPUT JACKS
VCR VIDEO INPUT JACK VCR VIDEO OUTPUT JACK
GB
STOP
TONE OPTICAL COAXIAL ANALOG
CROSS OVER
SUB WOOFER
ON/ OFF
SUB WOOFER
LEVEL
PLAY
Description
[
Remote Control
AMP button
POWER button
NUMBER(0~9) buttons
SLEEP button
INPUT MODE OPTICAL button
TONE button
EXTERNAL DEVICE PLAYBACK button
MUTE button
VOLUME CONTROL button
]
TV button
(Con’t)
DVD button VCR button
DIMMER button
TV/VIDEO
DRC button
INPUT MODE ANALOG button INPUT MODE COAXIAL button
CHANNEL button
,
FUNCTION button
CD button
VCR button
DVD button
Insert Remote Batteries
Remove the battery
1
cover in the direction of the arrow.
Follow these precautions to avoid leaking or cracking batteries:
Place batteries in the remote control so they match the polarity:(+) to (+)and (–)to (–).
•
Use the correct type of batteries.Batteries that look similar may differ in voltage.
•
Always replace both batteries at the same time.
•
Do not expose batteries to heat or flame.
•
Insert two 1.5V AAA
2
batteries, paying attention to the correct polarities (+ and –).
Replace the battery
3
cover.
PREP ARATION
MENU button
CUSOR/ENTER button
SUBWOOFER ON/OFF button
(You can view TV,DVD information on the TV screen.)
SPK DISTANCE button
INFO button
STEREO button
SPK LEVEL button
SFE MODE button
8
CROSS OVER button
SUBWOOFER LEVEL button
MODE button EFFECT button
TEST TONE button
SPK SELECT button
Range of Operation of the Remote Control
The remote control can be used up to approximately 7 meters in a straight line. It can also be operated at a horizontal angle of up to 30° from the remote control sensor.
9
11
GB
10
CONNECTIONS
•
Never touch speaker terminals while the power is on. Doing so could result in electric shock.
•
Make sure the polarities (+ and -) are correct.
FRONT SPEAKER PS-AF1T CENTER SPEAKER PS-AC1T SURROUND SPEAKER PS-AR1T
SYSTEM MODEL NAME : HT-AS1T
√ Connecting Speaker Wire
ACTIVE SUBWOOFER
(not supplied)
FRONT (R)
PS-AF1T
FRONT (L)
PS-AF1T
SURROUND (R)
PS-AR1T
SURROUND (L)
PS-AR1T
MAIN UNIT HT-AS1T
CENTER
PS-AC1T
1
Press the tab of the speaker connector.
2
Insert the black wire into the black(-) terminal and the gray wire into the red(+) terminal.

Connecting the Speakers

Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
•
Place these speakers behind your listening position.
•
If there isn't enough room, place these speakers so they face each other.
•
Place them about 60 to 90cm (2 to 3feet) above your ear, facing slightly downward.
❈ Unlike the front and center speakers, the surround
speakers are used to handle mainly sound effects and sound will not come from them all the time.
Surround Speakers
•
Place these speakers in front of your listening position, facing inwards (about 45°) toward you.
•
Place the speakers so that their tweeters will be at the same height as your ear.
•
Align the front face of the front speakers with the front face of the center speaker or place them slightly in front of the center speakers.
Front Speakers
•
It is best to install it at the same height as the front speakers.
•
You can also install it directly over or under the TV.
Center Speaker
•
The position of the Digital Amplifier/ subwoofer Speaker is not so critical. Place it anywhere you like.
Position of Digital Amplifier/ subwoofer Speaker
FRONT SPEAKER PS-AF1 CENTER SPEAKER PS-AC1 SURROUND SPEAKER PS-AR1
SYSTEM MODEL NAME : HT-AS1
ACTIVE SUBWOOFER
(not supplied)
FRONT (R)
PS-AF1
FRONT (L)
PS-AF1
SURROUND (R)
PS-AR1
SURROUND (L)
PS-AR1
MAIN UNIT HT-AS1
CENTER
PS-AC1
•
If more bass is desired, you can connect an additional active subwoofer (not supplied) to the Subwoofer 1or 2 port. Since the signal on the Subwoofer 1and 2 ports is not stereo, you will hear the same mono bass sound regardless of the port you connect to.
13
GB
12
CONNECTIONS

Connecting External Components

DVD Player
DVD Player
Connecting Video Component
•
Disconnect the power plug from the outlet if you will not use this unit for a long period of time.
•
In a DVD/CD player, you can select one digital audio input from OPTICAL and COAXIAL.
CD Player
Connecting Audio Component
VCR
TV
15
GB
14
To Select the Function
REMOTE CONTROL
MAIN UNIT
Press FUNCTION button.
•
Each time you press the this button, DVD ➝ VCR ➝CD will be selected in turn.
Method 1
Method 2
Press the FUNCTION button.
•
Each time you press the this button, DVD ➝ VCR ➝CD will be selected in turn.
Press CD, VCR or DVD button.
•
You can directly select CD, VCR or DVD .
Functions of Dedicated Remote Control
Connect the power plug to the outlet.
1
Press the POWER button of the main unit.
•
This unit will be turned on or set to Standby mode.
2
Connect the power plug to the outlet.
1
Press AMP button to set the remote to Amplifier mode.
2
Press the POWER button of the remote contr ol.
•
This unit will be turned on or set to Standby mode.
3
MAIN UNIT
REMOTE CONTROL
You can operate your AMP, TV, DVD, VCR with one remote control. See pages 44-47 for more details.

Before Using the Digital Amplifier Speaker

Turning On/Off
OPERA TION
Loading...
+ 18 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use