SAMSUNG F1015J Service Manual Disassembly & Reassembly

10-6 ASSY-TUB BACK
INNER-BEARING
A
C
OIL-SEAL
Assy-Tub Back REMARK
TYPE INNER-BEARING(A) OUT-BEARING(B) OIL-SEAL(C)
OUT-BEARING
B
Assy-Housing
Bearing(D)
I ø20 ø17 ø24.3 DC97-00125A DC97-00214K
10-7 ASSY- DRUM
A
B
(unit : mm)
C
TYPE
(A) (B) (C) CODE-NO. REMARK
I ø20 ø17 ø25 DC97-01463C Lifter type
10-8 ASSY-PUMP DRAIN
1) Capacity : AC 230V 34W
2) Location : Front bottom(R)
3) Resistance : 15Ω~18
Ω
25
(unit : mm)
12. Setting up a wash machine.
12-1 Remove the safety device for carriage
1) Remove 5 safety device volts with a enclosed wrench for safety device remove
2) Plug the 5 holes with 5 caps after removing the 5 safety device volts.
* Take care of 5 safety device volts and a wrench , you need these when you move wash machine safely.
Caution
You must remove safety device before use , if not, you have much vibration or much load can br impacted on
the machine.
1. Remove safety device behind of machine
To protect the machine, remove the
assembled 5 safety device
2. Plug the 5 holes
Plug the 5 holes after safety device
withthecapsenclosedinsideof
washing tub
12-2 Install the wash machine on the leveled place.
With the water level adjustment device, adjust the 4 adjustment legs to install the machine leveled on the right,
left, front and rear side. machine's install condition and size is following.
12-2-1 Initial assembled condition (ass'y cover top)
1) Adjustment legs are stick to the bottom of the machine,
when the machine comes out of factory. this condition is
ideal for vibration and noise.
2) When you install the machine initially or move the machine in use,
unscrew the 4 legs to the left and place the machine level and spin
the locking nuts and tighten it strongly.
29
12. Setting up a wash machine.
3) Even though adjustment legs came out all the way, if machine is not levled , prop up the
machine with the wood or brick to make it even.
(Do not use fragile material or slippery material such as laminated paper)
404598
4 4 8
7 1
12-2-2 The condition of setting up sink( Disassembled Ass'y- Cover Top)
1) Spin the adjustment leg to the left and remove them from the front and rear side of the machine.
2) Remove the 4 locking nuts from adustment legs, and put only adjustment legs back whert those were.
3) After removing the fixing screws(each on right, left side) from the machine whichi is behind ass'y- cover
top, disassemble the assy-cover top.
4) Install the sink.
598
1 2 8
1 1
404
30
Loading...
+ 4 hidden pages