For household use only
Pour utilisation domestique seulement
VACUUM CLEANER
ASPIRATEUR
Before operating this unit, please read the instructions carefully.
G
Avant d’utiliser cet appareil, veuillez lire les instructions attentivement.
G
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed,
including the following :
READ ALL INSTRUCTIONS BEFORE USING
THIS VACUUM CLEANER
WARNING
To reduce the risk of fire, electric shock, or injury.
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and
before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention is necessary when used by or
near children.
4. Use only as described in this manual. Use only manufacturer’s recommended
attachments.
5. Do not use with damaged cord or plug. If appliance is not working as it should,
has been dropped, damaged, left outdoors, or dropped into water, take it to a service center.
6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull
cord around sharp edges or corners. Do not run appliance over cord. Keep cord
away from heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked : keep
free of dust, lint, hair, and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all other parts of the body away from open-
ings and moving parts.
11. Do not vacuum anything that is burning or smoking, such as cigarettes, matches,
or hot ashes.
12. Do not use without dust bag and filters in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to vacuum flammable or combustible liquids such as gasoline or use
in areas where they may be present.
16. Store your vacuum cleaner indoors in a cool, dry area.
EN-1
17. Do not use extension cords or an outlet with inadequate current carrying capacity.
18. Hold plug when rewinding onto cord reel. Do not allow plug to whip when rewind-
ing.
19. Unplug electrical appliances before vacuuming them.
20. The hose contains electrical wires. Do not use if damaged, cut, or punctured. Avoid
picking up sharp objects.
21. Always turn off this appliance before connecting or disconnecting either hose or
motorized nozzle.
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug(one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way
EN-2
PARTS IDENTIFICATION
DUST-FULL INDICATOR
If the “Dust-Full” indicator switches to “RED” while you are cleaning, the dust bag is full
and must be replaced.
NOTE :
If the “Dust-Full” indicator continues to display “RED” even after changing
the dust bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged.
EN-3
ASSEMBLING THE VACUUM CLEANER FOR USE
Attaching the Hose to the Canister
Slide the Hose Clamper into the Canister lnlet
until it “clicks” into place.(Fig. A-A)
Assembling the Extension Wand
Slide the narrow end of one Extension Wand
section into the other Wand Extension.(Fig. AB)Depress the locking button with your thumb
and continue sliding the Extensions
together.Turn the Wands in opposite directions
until the locking button snaps into the hole in
the other Wand. Make sure the locking button
snaps into place completely.
Attaching the Extension Wand to the
Hose
Slide the handle end of the Hose over the end
of the Wand with a locking button.(Fig A-C)
Turn the Hose and Wand in opposite directions
until the locking button on the Wand snaps into
the hole on the Hose. Make sure the locking
button snaps into place completely.
Attaching the Power Brush
Slide the free end of the Extension Wand onto
the Power Brush Wand until the locking button
“clicks” into place.(Fig. B-A) Hold Power Brush
Electrical Cord against the back of the
Extension Wand.(Fig. B-B) Press Power Brush
Cord into the grooves of the Cord Clips.(Fig. BC) Plug the Power Brush Cord into the Hose
Electrical Outlet.(Fig. B-D)Your vacuum cleaner
is ready for use.
EN-4
POWER CORD
1) PULLING OUT
The power cord is long enough to be drawn out for
convenience.
2) REWINDING
Upon finishing cleaning, disconnect the plug from the
electri cal outlet and press the cord rewind button lightly
with your toe.
NOTE :
When removing the power cord from the electrical outlet, grasp the plug,
not the cord.
ON/OFF SWITCH
With the cord plugged into an electrical outlet,
start or stop the vacuum cleaner by stepping
lightly on the switch button.
POWER CONTROL
Vacuuming power can be adjusted to suit different situations using the power control.
MIN= For delicate fabrics, like net curtains.
MAX = For hard floors and heavily soiled
carpets.
USING THE ACCESSORIES
• Dusting brush - for furniture,shelves,books,etc.
• Upholstery brush - for cushions and drapery.
• Crevice tool - for radiators,crevices,corners,
between cushions.
• Power brush -The rotating brush ensures that
cleaning is carried out more thoroughly.
EN-5
OPERATING THE BRUSH HEAD
Push the ON/OFF switch(A) down.
(The brush switches on)
PARK POSITION
Located in the top rear side of the vacuum
cleaner, there is a support for a convenient
park position during pauses when using the
nozzle.
TRANSPORTING AND STORING THE VACUUM CLEANER
For easy storage and transportation, this vacuum cleaner has a clip system built onto the
body, which will keep the tube, hose and nozzle in a vertical position.
REPLACING THE DUST BAG
1) To open the dust cover of the dust
bag com partment, press the clamp
upward located at the side of the
dust cover.
2) Remove the dust bag from the
cleaner.
EN-6
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.