Samsung BTW200 Users Manual

SPECIFICATION FOR APPROVAL
Customer:
Address:
Part No. BTW200
Description:
Manufacturer
Vendor:
Samsung Electronics Huizhow CO., LTD.
Approved by: BLUE TEK CO., LTD.
Approved
MM/DD/YY: 01/ 03 /2005
Date:
BLUE TEK CO., LTD.
416, Maetan-3Dong, Paldal-Gu, Suwon City, Kyungki-Do, Korea 442-742 TEL: +82-31-200-8672 FAX:+82-31-200-4390
http://www.bluetek.co.kr
1
Abbreviations
. ADC: Analog to Digital Converter . AGC: Automatic Gain Control . ANT: Antenna . BBP: Base Band Processor . bps : Bit per second . BT : Bluetooth . DAC: Digital to Analog Converter . FHSS : Frequency Hopping Spread Spectrum . GFSK : Guassian Frequency Shift Keying . ID : Identification . I/O: Input/Output . ISM: Industrial Scientific Medical Frequency Band . LDO: Low Drop Out Regulator . LNA: Low Noise Amplifier . L/R : Left/Right . MCU: Micro Process Unit . PA: Power Amplifier . PCM : Pulse Code Modulation . RF: Radio Frequency . SAW: Surface Acoustic Wave . SMD: Surface Mounted Device . Tx : Transmitter . Rx : Receiver
.
2
1. Introduction
This document is manual for BTW200 module. BTW200 module is for sending & receiving audio data without wire. Transmission methods are FHSS(Frequency Hopping Spread Spectrum) which is used in bluetooth technology.
BTW200 is composed of two parts. One is Tx module and the other is Rx module. Tx module is works for master, which receives and compresses audio signal at baseband chip and sending signal without wire. Rx module is works for slave, which receives signal without wire. The both modules can send and receive data each other.
This system is for sending and receiving wireless digital data with CD audio quality. The following characteristics are for satisfying quality.
- Bluetooth RF chip is used for RF function without wire.
- DWM3100 supports audio interface, works for compressing & decompressing and controls audio codec & RF modem chip.
- Real-time sending and receiving are available.
- It could works independently without S/W control. To loading parameter for operating DWM3100 when you turning on the power, Booting EEPROM(128 bytes or 256 bytes) is implemented on set. In addition, I2C mater function is included for accessing EEPROM.
- There is another interface for testing system, additional data interface a nd controlling other system.
- CD audio quality is available.
- Data transmission is possible.
- Can avoid interference with other wireless products.
- Operation clock and master clock are used.
32MHz clock for baseband part and RF
2. Standard and general specification
2.1 Standard Specification
- 1Mbps high quality audio data communication
- FHSS
- 2.4GHz ISM band
2.2 General Specification
3
Loading...
+ 4 hidden pages