i. RF exposure warning statement – for keeping 20cm distance when installing this module.
ii. Warning that this module should not be installed and operating simultaneously with other radio without
WARNING
additional evaluation or FCC ling.
iii. instruction for host system labeling, the host system should have proper label showing that it "Contains FCC ID :
[Connecting Network]
Connect the wireless IP router to an air conditioner.
[Registering service]
Access the http://www.samsungsmartappliance.com
and register the service.
Checking before using a wireless router
This Wi-Fi Aircon support only below three encryption.
- Open (No encryption), WPA/TKIP, WPA2/AES
- You may not be able to establish Wi-Fi connection if other type of encryption is used.
f For Wi-Fi Aircon installation, select indoor unit location near to wireless router. In case Wi-Fi signal strength is weakened,
Smart App. may be disconnected depending on the Wi-Fi signal strength.
f Smart-Phone should be in the Wi-Fi signal zone to use Smart App.f For Mobile broadband internet access, Smart App. can be used when Mobile Broadband Dongle is activated to use Wi-Fi.f This product supports only DHCP(Dynamic Host Conguration Protocol ). If users use an existing wireless router, the
DHCP server option function should be activated.
f Select a channel for the wireless router that is not currently being used. f If a wireless router is connected by other than the above modes, the router may not be connected with the air
conditioner or may not work. To use 802.11n, using WPA2/AES is recommended.
f The quality of wireless network connection can be aected by the surrounding wireless environment.f If an internet service provider has permanently registered the users PC or MAC address (a unique identifying number),
the air conditioner might not be connected to internet. When appliances other than a PC are to be connected to Internet,
ask your ISP (Internet service provider) about the procedures required to connect to the internet.
f If your internet service provider requires an ID or a password to connect to the internet, your air conditioner may not be
able to connect to the internet. If this is the case, you must enter your ID or password when connecting to the internet.
f The internet connection may fail because of a rewall problem. If this is the case, contact your internet service provider.f If you cannot connect to the internet even after you have followed the procedures of your internet service provider,
please contact a samsung service center.
PREPARATION01
Connecting network
Connecting the wireless IP router with an air conditioner
f For wireless router installation, refer to the user manual of the
corresponding router.
f Samsung smart air conditioner supports the communication
protocols of IEEE802.11 b/g/n(2.4Ghz).
f For wireless router installation, refer to the user manual of each
manufacturing company.
Samsung does not provide customers with the wireless router
manual.
f Uncertied router may not be able to connect with an air
conditioner.
f Certied router has the logo of below on the package or user
f Open the lter cover and check the Wi-Fi Module (①) attached on the panel front. The connection status between the
Wi-Fi module and the wireless router can be checked by the Wi-Fi module described next page.
f To replace the Wi-Fi module(Assembling or disassembling), follow the procedure below.
• When changing the Wi-Fi module, you should check the MAC attached on the module or bottom part of the indoor
unit and modify the device information at ‘Registering service’.
NOTE
Disassembling the Wi-Fi module
1. Remove the cover of the sub panel.
2. Disconnect the wire of the Wi-Fi module.
3. Release the hook on the top of the Wi-Fi module and push it up to disassemble it.
Check whether the wireless router connects with a smart phone.
When the internet is not connected with a smart phone, the network function of the air conditioner cannot be used.
1. Search for the wireless router on the smart phone.
2. Select the wireless router you are using now on the searched wireless router list.
3. Check whether the smart phone can access the website http://www.samsungsmartappliance.com by the internet.
• If you need ID and Password to use the internet at commercial building, inform the network administrator of MAC
NOTE
address of your air conditioner and get the approval of internet use for the air conditioner.
• If private program installation of ISP is needed for internet use, the air conditioner cannot be connected with the
Connecting the wireless router with an air conditioner by the network (Select one of the 2 methods)
Connecting network with a Smart phone APP
Setting application on Samsung smart phone (Android based smart phone )
• Android based smart phone users can download the Smart A/C application by searching ‘Samsung, Smart, A/C, AC,
Air, Conditioner’ at android market or Samsung Apps.
NOTE
PREPARATION01
1-2
1-1
2
1. After pressing the [2ndF] button on the remote controller, press the [Wi-Fi] button.
- message will be displayed on the front display panel of the air conditioner.
2. After operating Smart A/C application, press the [Network Setting] tab.
3. Press the [Setting Start] tab.
• The program version of the picture in this manual is only for reference. Please according to the actual.
4. Select the wireless router that you are using now.
- When using free wireless router, refer to the corresponding user manual for password.
5. After entering the password of selected wireless router, press the [OK] tab.
- When the password has not been set, press the [OK] tab without entering the password.
6. When 'Transfer complete' pop up comes on, press the [OK] tab.
- When the Wi-Fi ( ) indicator is on, the air conditioner is connected with wireless router and the internet.
- When the Wi-Fi ( ) indicator blinks, the air conditioner is connected to wireless router but not with internet. In this
case, check the internet connection.
- When the Wi-Fi ( ) indicator is o, the air conditioner is not connected with wireless router and the internet.
7. After 1~2 minutes, if the Wi-Fi LED of the air conditioner is still on, it means the conguration has succeeded. At this point,
you can use smart phone to control the system.
• When searching a network by pressing the [Wi-Fi] button, message will be displayed on the front display a
maximum of 5 minute.
NOTE
• Smart A/C application is optimized with Samsung smart phones. Supported models are; Samsung Galaxy Phone
series and other models can be added in the future. When the Smart A/C application is used with other smart