Samsung AQT24 Disassemble

4. Disassembly and Reassembly

Stop operation of the air conditioner and remove the power cord before repairing the unit.

4-1 Indoor Unit

No Parts Procedure Remark

1 Front Grille 1) Stop the air conditioner operation and block

the main power.

2) Seperate tape of front panel upper.

3) Contract the second finger to the left, and
right handle and pull to open the inlet grille.

4) Take the left and right filter out.

* Take the Deadorizing and Electrostatic fil-

ter out.
(ONLY “1” and “5” Series models)

5) Loosen one of the right fixing screw and
seperate the terminal cover.

6) Loosen two fixing screws of front grille.

7) Pull the upper left and right of discharge
softly for the outside cover to be pulled out.

8) Pull softly the lower part of discharge and
push it up.

Caution;

Assemble the front panel and fix the
hooks of left and right.

4-1

Samsung Electronics

Disassembly and Reassembly

No Parts Procedure Remark

2

Ass’y Tray Drain.

1) Do “1”, above.
Separate the drain hose from the extension
drain hose.

2) Take the display PCB out.
(Center of indoor unit)

3) Loosen two fixing screws of left and right

4) Pull tray drain out from the back body.

3

Electrical Parts

1) Do “1”, “2”, above

(Main PCB)

2) Take all the connector of PCB upper side out.
(Inclusion Power cord)

3) Separate the outdoor unit connection wire
from the terminal block.

4) If pulling the Main PCB up. it will be taken
out.
(Separate the TRANS hook. it before).

4

Heat Exchanger

1) Do “1” and “2”, “3”, above

2) Loosen two fixing earth screws of right side.

3) Separate the connection pipe.

4) Separate the bush body at the upper side and
holder at the rearside.

5) Loosen the two fixing screws of left side.

6) Lifting the heat exchanger up a little to push
the up side for separation from the indoor
unit.

Samsung Electronics

4-2