Part #: 34-30-321
TABLE OF CONTENTS
S P E C I F I C A T I O N S |
P a g e 1 & 2 |
H A N D L I N G A N D I N S T A L L A T I O N |
P a g e 3 |
|
|
P R I Z E V E N D I N G U N I T S |
P a g e 4 |
HOW TO ADJUST THE VENDING UNITS FOR YOUR PRIZES |
|
|
|
P R I Z E S |
P a g e 5 & 6 |
PRIZE SIZES |
|
SIZE OF KEY CHAIN & LOOP |
|
HOW TO FILL THE PRIZES (PRIZE FILLING MODE) |
|
|
|
G A M E S E T T I N G M O D E |
P a g e 7 & 8 |
HOW TO ENTER THE GAME SETTING MODE |
|
HOW TO ADJUST THE GAME SETTING STYLE |
|
IF YOU HIT THE CLEAR SWITCH DURING THE GAME SETTING MODE.... |
|
SETTING FUNCTIONS |
|
T A B L E O F S E T T I N G F U N C T I O N S |
P a g e 9 - 1 1 |
|
|
T E S T M O D E |
P a g e 1 2 & 1 3 |
HOW TO ENTER THE TEST MODE |
|
HOW TO GO BACK TO THE REGULAR GAME MODE |
|
E R R O R S |
P a g e 1 4 |
TILT |
|
COIN ERROR |
|
PRIZE VENDING ERROR |
|
C U S T O M M A R Q U E E S E T - U P |
P a g e 1 5 |
P A R T N U M B E R S |
P a g e 1 5 |
|
|
E L E C T R I C A L W I R I N G D I A G R A M ( U S A & C A N A D A , E U R O P E ) |
P a g e 1 6 & 1 7 |
|
|
S P E C I F I C AT I O N S
POWER |
120VAC @ 60Hz |
USA & CANADA |
|||
|
|
230VAC @ 50Hz |
EUROPE |
||
DIMENSIONS |
Width: |
19 1/4” |
( 489 mm) |
||
|
|
Height: |
70” |
( 1777 mm) |
|
|
|
Depth: |
24 1/2” |
( 623mm) |
|
WEIGHT |
250 lb |
(114 kg) |
|
|
|
|
|
|
|
|
|
Tempered Glass Front
Door
Part #: 34-70-477
70” |
Stop Button |
|
Part #: 99-50-012 |
24 1/2”
19 1/4”
1
SPECIFICATIONS (CONT.)
LIMITED WARRANTY
Sammy USA Corp. warrants all products to be free from defective materials and workmanship for a period of thirty (30) days from the Sammy USA Corp. invoice date unless otherwise specified in writing by Sammy USA Corp. The extent of this warranty applies to all electronic assemblies only, and does not include lamps and fuses.
This limited warranty is invalid for any product that upon examination is deemed to have been subject to misuse, improper repair or installation, neglect or violation of specifications or other instructions published by Sammy USA Corp. There are no additional warranties described above. The limited warranties described above shall be in lieu of any other warranty, expressed or implied, including but not limited to any implied warranty of merchantability or fitness for a particular purpose.
2
H A N D L I N G A N D I N S TA L L AT I O N
PLEASE TAKE A MOMENT TO READ THE FOLLOWING BEFORE YOU TURN ON YOUR NEW GAME.
The Sports Arena prize redemption game is an indoor game machine. It is not designed for outdoor use. Avoid installing the game in the following locations:
Locations subject to rain or water damage
Locations in direct sunlight
Locations subject to extreme heat
Locations near hazardous or flammable liquids or chemicals
You will need the following dimensions of space for your machine to be properly installed into your location:
72 inches height
25 inches in width
INSTALLATION
Unpack your game carefully. Be careful of the shipping staples. They can be sharp.
Your game is assembled and will not need any assembly.
Level your game using enclosed Leg levelers. Prizes will then fall properly.
The standard voltage for U.S. and Canada 120V / 125V - 3A; Europe 220V / 240V - 2A.
Use of extension cords is prohibited.
Use only a grounded outlet. YOUR GAME MUST BE GROUNDED!!!
The minimum space required for operation in your locations should be:
69” high
19” wide
24.5” depth
THE GAME MUST BE LEVEL. IF THE GAME IS NOT ON A LEVEL SURFACE, THE TILT SYSTEM WILL MALFUNCTION. USE A LEVEL TO AVOID NEEDLESS ADJUSTMENTS.
SAFETY PRECAUTIONS
Be sure to turn the power off or unplug the game before working on the unit.
Do not unplug game by pulling on the line cord.
Replace line cord if the insulation is damaged in any way with one of equal quality.
Replace open fuses with same type and rating.
Re-check and re-seat all harness connections.
3
C A R O U S E L U N I T S |
|
Carousel Unit U1 |
|
Carousel Unit U2 |
|
Carousel Unit U3 |
|
24W, 5V Bulb, Red |
24W, 5V Bulb, Clear |
Part #: 99-60-256 |
Part #: 99-60-255 |
HOW TO ADJUST THE VENDING UNITS FOR YOUR PRIZES
You can adjust each Carousel Unit level for your prize size.
1Take off 2 screws from the Carousel Unit Cover.
2Take off 2 screws from the Carousel Unit Frame.
3Adjust the Carousel Unit Frame onto one of 3 levels for your prizes.
Carousel Unit Cover
Part #: 99-70-476
Back of the Carousel Unit |
|
|
Belt |
|
Part #: 99-70-911 |
|
TOP |
|
MEDIUM |
Gearbox |
|
Part #: 99-60-335 |
BOTTOM |
|
|
Carousel Unit without Cover
Part #: 99-50-451
Carousel Motor |
Prize Hanger |
Part #: 99-60-334 |
Part #: 99-70-474 |
Prize Pusher Bracket
4
Loading...