Salus RT305TX Instruction Manual

Digital Room Thermostat RT305TX
The RT305TX can be used with any of these receivers
868MHz
RXRT505
RXST625
RXBC605
RXVBC605
RT305TX Digital Room Thermostat
2
RT305TX INSTRUCTION MANUAL
PRODUCT COMPLIANCE
This product complies with the essential requirements of the following EC Directives:
Electro-Magnetic Compatibility directive 2004/108/EC
Low Voltage Directive 2006/95/EEC
EC Marking directive 93/68/EEC
SAFETY INFORMATION
These instructions are applicable to the SALUS Controls model stated on the front cover of this manual only, and must not be used with any other make or model. These instructions are intended to apply in the United Kingdom only, and should be followed along with any other statutory obligations.
When fitting batteries don’t mix old and new batteries together. Do not use rechargeable batteries.
Please leave these instructions with the end user where they should be kept in a safe place for future reference.
RT305TX INSTRUCTION MANUAL
3
INTRODUCTION
An RF thermostat is a transmitter that allows control of a heating system with no physical connection between the thermostat and the boiler. This digital thermostat is used to switch the heating system in your home on and off as needed. It works by sensing the air temperature and switching on the heating when the air temperature falls below the thermostat setting, and switching it off once the set temperature has been reached. The RT305TX from SALUS Controls is a stylish and accurate digital thermostat with a large, easy to read Liquid Crystal Display (LCD).
This thermostat can replace most common residential thermostats and is designed to be used with electric, gas or oil heating control systems. Unlike ordinary single unit design thermostats, this is a new type of thermostat separating the operational functions into two units.
The Receiver is used for wiring connections and heat on/off control. The thermostat provides the user interface and temperature sensing /control. The two units are linked together by a Radio Frequency (RF) signal.
Features
Frost protection
Large, easy to read LCD with blue backlight
Burner on symbol
User friendly
4
RT305TX INSTRUCTION MANUAL
INSTALLATION
Please read the important safety information at the start of this manual before you begin to install the device. location by using the included stand, or can be easily installed in a fixed position using the industry standard back plate supplied with the unit – this is used purely for mounting purposes, as no wiring is needed for the RT305TX. The back plate can be mounted directly to the wall surface.
The ideal position to locate the RT305TX thermostat is about 1.5m above floor level. It should be mounted in a location where the thermostat is accessible, reasonably lit and free from extremes of temperature and draughts. Do not mount the thermostat on an outside wall, above a radiator or in a location where it may be subjected to direct sunlight. To ensure trouble free operation of the Radio Frequency (RF) signal, always ensure that the programmable thermostat is mounted away from any possible sources of interference (such as radios, TV sets, computers, etc.), and is not mounted on or in close proximity to large metal objects. Installing the RT305TX in enclosed areas such as cellars and basements is not recommended.
The RT305TX can be used in any convenient
AFTER INSTALLATION
The following table shows the settings of the RT305TX digital thermostat after Power on, or after RESET is pressed:
Function Status After Reset or Power On
Operation Mode Normal mode Room Temperature 22.0 °C, updated within 5 seconds Set Point Temperature Default factory setting Frost Protection indicator Off Heat indicator Off Low-Battery Warning indicator Off, updated within 5 seconds Output Relay Off
RT305TX INSTRUCTION MANUAL
5
Loading...
+ 11 hidden pages