Salus OPTIMA ZigBee User Manual

'

Version'1.0'

Salus Controls Inc.

123 Townsend St. Level LL2

San Francisco, CA 94107

For other language versions, please visit: www.salusinc.com

OPTIMA'ZigBee'Thermostat'

'

User'Manual'

ii' Salus

User'Manual'

!"#$%&'()!%*+,%(-)!'

Please read these instructions carefully before installing and using
the OPTIMA thermostat, and keep this guide in a safe place for future
reference.

• Follow all local and electricity supplier regulations regarding the
installation or replacement of a thermostat. An authorized,
qualified installer may be required.

• Do not connect any of the terminals to the 110/220 VAC
supply. The OPTIMA thermostat uses two AA batteries or a 24

VAC power source.

• Do not cover any of the vents on the thermostat.

• Do not install this unit at an altitude over 2000 meters.

• Do not place the unit in a bathroom or area of excessive

moisture. Do not allow the unit to get wet. This device serves as
a temperature control system only in dry, closed living and office
spaces.

• Do not expose the unit to temperatures below 5°C or above
40°C, humidity above 80%, or pollution above level 2.

OPTIMA'ZigBee'Thermostat' 33'

'

#,,'./0'(/012345',./.0.'

RF Radiation Exposure statement: This equipment complies with FCC and
Industry Canada RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the antenna and all persons.

(/012345',./.0.'

Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.

This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.

32' Salus

User'Manual'

"66$)7(8'9':'*$;+<"%-*&'!%"%$=$)%!'

#,,'!3.3>?>/32'

WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

OPTIMA'ZigBee'Thermostat' iii'

'

• Do not expose the unit to voltage fluctuations more than +/-
10%.

• Do not use solvents or aggressive cleaning agents. A dry, soft
cloth is recommended.

The manufacturer accepts no responsibility for damage caused by
not following these instructions.

'

iv' Salus

User'Manual'

,-)%$)%!'

IN#THE#BOX# 1!

CONTROLS#AND#DISPLAY# 2!

BUTTONS! 2!
HOME!SCREEN! 4!

INSTALLING#THE#THER M OSTAT# 6!

TOOLS! 7!
TURN!OFF!POWER!TO!HVAC!SYSTEM! 7!
DETERMINE!WIRING!CONFIGURATION! 7!
REMOVE!OLD!THERMOSTAT! 9!
INSTALL!MOUNTING!PLATE! 9!
ATTACH!WIRING! 10!
INSTALL!BATTERIES! 10!
INITIAL!CONFIGURATION! 11!
ATTACH!THERMOSTAT!TO!MOUNTING!PLATE! 12!
TURN!POWER!BACK!ON!TO!THE!HVAC!SYSTEM! 12!
CONFIGURE!THERMOSTAT! 12!

OPTIMA'ZigBee'Thermostat' 31'

'

%@A'%4./2BA4?>4'C>.3'61?D'!523>?'

30' Salus

User'Manual'

!E/FG>'%4./2BA4?>4'C>.3'61?D'!523>?'

OPTIMA'ZigBee'Thermostat' v'

'

USING#THE#THERMOSTAT# 13!

CHANGING!THE!SET!POINT!TEMPERATURE! 13!
SETTING!A!HOLD!SET!POINT!TEMPERATURE! 14!
CHANGING!THE!OPERATING!MODE! 15!
TURNING!ON!THE!FAN! 15!

CONFIGURING#THE#THERMOSTAT# 16!

CONFIGURATION!MENUS! 16!
RESET!TO!DEFAULTS! 21!

SPECIFICATIONS# 22!

TROUBLESHOOTING# 23!

SALUS#WARRANTY# 23!

APPENDIX#A#–#WIRING#DIAGRAMS# 26!

TERMINAL!DEFINITIONS! 26!
CONVENTIONAL!SINGLE!TRANSFORMER!HEAT!AND!COOL!SYSTEM! 27!
CONVENTIONAL!TWO!TRANSFORMER!HEAT!AND!COOL!SYSTEM! 28!

vi' Salus

User'Manual'

FLOOR!HEATING!SYSTEM! 29!
SINGLE!TRANSFORMER!HEAT!PUMP!SYSTEM! 30!
TWO!TRANSFORMER!HEAT!PUMP!SYSTEM! 31!

APPENDIX#B#–#REGULATORY#STATEMENTS# 32!

FCC!STATEMENTS! 32!
FCC!AND!INDUSTRY!CANADA! 33!
INDUSTRY!CANADA! 33!

'

OPTIMA'ZigBee'Thermostat' 29'

'

#GAA4'C>.3E/F'!523>?'