SALTON DA1084 User Manual
PHOTO FRAME BABY MONITOR
DA1084PT “Playtime” • DA1084BL “Bunny Luv”
Westinghouse, (W) and “YOU CAN BE SURE... IF IT'S WESTINGHOUSE” are
trademarks of Westinghouse Electric Corporation used under license by Salton, Inc
CAUTION
!
g
This product cannot replace responsible adult supervision.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Read all instructions.
2. Keep a distance of at least three feet between transmitter and child when using the
system for baby monitoring.
3. This system cannot replace responsible adult supervision of a child or person
requiring care, but act only as a support!
4. This product is not intended to be used as a medical monitor and its use should not
replace adult supervision.
5. Test sound reception of receiver before first-time use and whenever you change the
location of the transmitter.
6. To prevent entanglement:
◆
Never place transmitter in a crib or playpen. Keep transmitter and receiver out of
baby’s reach.
◆
Never use extension cords with the AC adaptor.
7. Never use transmitter or receiver near water (i.e., bathtub, sink, laundry tub, wet
basement, etc.).
8 . Always use transmitter and receiver where there is adequate ventilation. To pre v e n t
overheating, keep transmitter and receiver away from heat sources such as radiators,
heat registers, direct sunlight, stoves, amplifiers, or other appliances that produce heat.
9. Excess dirt in transmitter microphone will hamper transmission of sound. Clean outer
surface of transmitter and receiver with a cloth lightly dampened with a mild cleaning
solution.
10. Never immerse transmitter, receiver, or AC adaptors in water.
Thank you for purchasing this Baby Monitor with Picture Frame!
For proper set up and use, please read these instructions.
Please keep this instruction booklet for future reference
as it contains important information.
CONSUMER INFORMATION
Occasionally, a consumer may experience a problem with one of our products. If this
should happen, please call us toll-free, rather than return this product to the store.
Usually, we can solve the problem over the telephone or send you replacement parts.
Please call Westinghouse®Consumer Information at (800) 934-7455.
TECHNICAL DATA
Channel 1 frequency: 49.830 MHz
Channel 2 frequency: 48.873 MHz
AC adaptor: 9 volt 100MA / 120v ~, 60 Hz
Transmitter battery: 9 volt Block / Alkaline (not included)
Receiver battery: 9 volt Block / Alkaline (not included)
The maximum operating distance is 150m (open area) in ideal conditions.
INSTRUCTIONS FOR USE
BATTERY SAFEGUARDS
◆
Remove the battery during long periods of non-use. Always remove an exhausted
battery from the product. Battery leakage and corrosion can damage this product.
Dispose of battery safely.
◆
Do not dispose of battery in a fire. The battery may explode or leak.
◆
Never short circuit the battery terminals.
◆
A non-rechargeable battery is not to be recharged.
◆
If removable rechargeable battery is used, it is only to be charged under adult supervision.
◆
A rechargeable battery is to be removed from the product before it is charged.
◆
If you use a battery charger, it should be examined regularly for damage to the cord,
plug, enclosure and other parts. Do not use a damaged battery charger until it has
been properly repaired.
SAVE THESE INSTRUCTIONS — For Household Use Only
Power Options
This product includes two AC adaptors to power transmitter and receiver (plugs into standard household outlets – 120V AC). Both transmitter and receiver also run on DC battery
power (9V alkaline battery – not included).
Setup and Use
1. Connect the appliance plug of the power adaptor to the power supply bushes of the
transmitter and receiver.
2. Devices can also operate by DC battery power. Open the battery door and insert a
9V battery into the battery compartment.
Note: When the unit is operated by DC battery, if static is transmitted more
frequently, please replace battery with a fresh 9V alkaline battery.
Loading...