Salora CR606USB User Manual

Download

Page 1

8&,,&33"%*0.&564#01-"%&3 ($*,&34)"/%-&*%*/(

 - 

3"%*03&7&*-"7&$$)"3(&6364# ."/6&-%*/4536$5*0/4

"-"3.$-0$,3"%*08*5) 64#$)"3(*/(

64&3."/6"-

$364#

 - 

 - 

Page 2

LOCATION OF CONTROL

1. Alarm 1 indicator

2. Alarm 2 indicator

3. USB charging port

4. DC5V jack

5. MINUTE / TUNING button

6. TIME / MEMORY button

7. POWER ON/OFF / ALARM OFF/ MODE button

8. HOUR / TUNING button

9. VOLUME - / ALARM 2 button

10. VOLUME + / ALARM 1 button

11. SLEEP button

12. SNOOZE button

13. AC adaptor (not shown)

5 6

7 8

10 11

POWER SUPPLY

Mains supply : Insert the AC adaptor into a 230V AC ~ 50Hz mains outlet and the other

end of the cord into the DC 5V jack (4) on the back of the unit. Battery back up : The clock time and alarm (if set) can be maintained during a power

failure by 2 x AAA/ LR03 batteries (not supplied). Once the power is restored, check the time to make sure it is accurate and re-set if necessary.

Inserting the Batteries

1. Open the battery compartment at the bottom of the unit by pressing on the catch and removing the cover.

2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment, following the polarity as shown on the diagram inside the compartment.

3. Replace the battery compartment cover

SETTING THE CLOCK AND ALARM

Setting the clock

1. Press and hold the TIME button (6) and the hour/minute digits will ﬂash.

2. Use the HOUR button (8) to set the hours.

3. Use the MINUTE button (5) to set the minutes.

4. Press the TIME button (6)to conﬁrm.

Setting the alarm

Before setting the alarm time, make sure the Clock has been set.

1. In standby mode, press and hold AL1 (10) / AL2 (9) until “0:00” ﬂashes on the display.

2. While “0:00” is ﬂashing, set the alarm time by repeatedly pressing HOUR / MIN. Press and hold HOUR (8) / MIN (5) respectively for fast advance.

3. Repeatedly press AL1 (10) / AL2 (9) to select the desired alarm mode (1) (2) (buzzer or radio).

Page 3

Using the Alarm Function

1. To enable the alarm function, use the ALARM 1/2 buttons (9) (10) to select buzzer or radio. The selected alarm mode indicator will light up.

2. The buzzer or radio will come on at the set time.

3. To stop the alarm, press the AL OFF button (7). The alarm will sound again the next day.

Note: While the buzzer alarm volume is ﬁxed and cannot be adjusted, the radio alarm volume can be adjusted to your desired level using the VOLUME buttons (9) (10). To select a radio station to wake up to, see the section on “USING THE RADIO”.

Snooze function

When the alarm sounds, press the SNOOZE button (12). The alarm mode indicator will ﬂash and the alarm will sound again after 9 minutes. To cancel the SNOOZE function

and repeat the alarm the next day, press the AL OFF button (7).

Sleep Function

With this function, you can listen to the radio for up to 90 minutes, after which it will turn off automatically.

1. When the unit is switched on, press the SLEEP button (11) repeatedly to select the duration: 90, 80, 70, 60, 50, 40, 30, 20, 10 minutes or OFF.

2. At the end of the set time, the radio turns off automatically.

3. To cancel the sleep function before the end of the set time, press the button to turn off the radio immediately.

USING THE RADIO

1. Press the button (7) to turn on the radio.

2. Press and hold one of the <TUNING> buttons (5) (8) to start automatic tuning up/ down. Release the button when the unit is receiving a station you would like to listen to. For manual ﬁne-tuning, you can press it brieﬂy to adjust the frequency step by step.

3. Press the button (7) to turn off the radio.

For optimum reception

Extend and position the FM antenna to achieve optimum reception.

Preset radio stations

You can store up to 10 stations.

1. Use the <TUNING> buttons (5) (8) to search for a station. Press and hold the MEMORY button to store the station and a number to be assigned for the preset will be ﬂash.

2. Press the <TUNING> buttons to change the number.

3. Press the <MEMORY> button again to conﬁrm the setting.

Listening to a preset station

While listening to the radio, press the MEMORY button to select a preset station. The current time is always displayed. When you change to Radio mode, the frequency will be displayed for 5 seconds and then the unit will go back to displaying the time.

USB CHARGING FUNCTION

To charge, connect your USB device like smartphone to the USB port of this clock. Use only with devices that require 5V USB power. USB port provides 1000mA recharging

Page 4

current. Devices requiring more than 1000mA should not be used. Charging time may vary for difference devices.

Note: Charging function may not be supported for all phones or electronic devices.

Charging output would be around 80% in radio mode.

WARNINGS

This appliance is intended for domestic household use only and should not be used for any other purpose or in any other application, such as for non-domestic use or in a commercial environment. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

No naked ﬂame sources, such as lighted candles, should be placed on the apparatus. The apparatus shall not be exposed to dripping or splashing and that no objects ﬁlled

with liquids, such as vases, shall be placed on the apparatus. Ventilation Allow at least a 10 cm gap all around the product.

This apparatus is not suitable for use in a tropical climate. Prior to cleaning or other maintenance, the appliance must be disconnected from the

supply mains. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, ﬁre or the like.

To protect the environment, use local recycling facilities for battery disposal. Where the MAINS plug or an appliance coupler is used as the disconnect device, the

disconnect device shall remain readily operable. The marking plate is located on bottom of the enclosure.

SPECIFICATIONS

FM: 87.5-108 MHz Power supply: AC 230V~ 50 Hz Back-up batteries: 2 X 1.5V “AAA” size batteries or equivalent (not included)

Electrical products should not be disposed of with household waste. We kindly ask that you use the recycle collection points provided for this purpose. Consult with your local authorities or dealer for advice on recycling.

We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development.

SALORA | Vareseweg 44 | 3047AV | Rotterdam | The Netherlands