SA jiffy User Manual

m

anual

bedienungsanleitung

b

rugsanvisning

SA jiffy

Manual (English)

Thank you, for choosing SA. This manual will help you
getting correctly started with your new loudspeakers.
Follow the instructions of the manual to obtain the best
sound. Please, note that the loudspeakers need
approximately 50 hours burn in before the sound is
optimised. There are no special precautions during the
burn in period.

check the serial number

At the rear of the loudspeaker you will find a label with the
serial number. It is a good idea to write the serial number down
on the invoice from the dealer and save it together with your
insurance documents. Contact your dealer if there is no serial
number on the loudspeakers.

connecting the loudspeaker to the amplifier

At the rear of the loudspeaker you will find the input terminal.
This is where you connect the cable from the amplifier output
to the loudspeaker. The red terminal is positive the black is
negative. Make sure that the cable is correctly connected so
that + on the amplifier is connected to + on the loudspeaker.
The right and the left channel should also be correctly
connected. Make sure that the connection is solid and clean.

a good installation of the loudspeakers is vital to obtain a
good sound

Place the loudspeakers 2 or 3 metres apart from each other.
The sound from the loudspeakers should be able to find its
way to your preferred listening position unobstructed.
Be aware that:

• the bass level is increased when the loudspeaker is
placed close to a wall, and reduced by making the
distance to the wall bigger

• the sound gets clearer if the loudspeakers are
angled towards the listening position

• the sound is not optimised if the loudspeakers are
placed high without being angled downwards

• the sound is not optimised if the loudspeakers are
placed low without being angled upwards

original accessories facilitate the installation

A compact loudspeaker can be freely placed anywhere. SA
has made it easy to use this freedom by having prepared your
loudspeakers using either the built-in wall brackets or floor
stand.
In the SA catalogue you will find a list of the different kinds of
accessories. See also www.system-audio.com

cleaning the SA loudspeakers

The sides of the loudspeakers are cleaned with a moist cloth.
The front grill is carefully cleaned with a vacuum cleaner with a
brush mounted on the mouthpiece. Avoid touching the
membranes of the loudspeakers and do not use any strong
detergents.

special precautions as to the rear speakers

The rear speakers are placed higher than the other
loudspeakers of the home theatre system, typically higher than
120cm above the floor. They can be placed behind the
listening position or beside it, but never in front of it. The rear
speakers contribute to giving a feeling of “being part” of the
movie. Therefore they must be placed so that you sit in front of
(or opposite) the rear speakers. Refer to your surround
amplifier manual for correct adjustment of the sound level
between the loudspeakers of the system. The rear speakers
are connected to the special rear speaker output of the
amplifier.

warranty

System Audio A/S grants 2 years warranty against
manufacturing defects. The warranty does not cover misuse.

The dealer or an associated workshop performs repair or
inspection. The warranty is valid, as long as there have been
no modifications to the construction.

this is how you make the most of your SA loudspeakers

• Use some time experimenting with the position of
the loudspeakers

• Give the speakers some time to burn in

• The better your HiFi system is, the better your

loudspeakers sound

• Good cables will improve the sound noticeable

• Never play louder than it still sounds good

• Remove the front grill for serious listening sessions

• Visit System Audio’s Internet homepage

www.system-audio.com, where you can find more
advice and manuals.

System Audio A/S
Klosterengen 137 K
4000 Roskilde
Denmark

Internet: www.system-audio.com
SA is a registered trademark

the FS3 speaker stand