Ryobi P900 User Manual

MEDIUM TOOLBOX

P900

The Ryobi toolbox is a great way to keep your hand tools organized, accessible, neatly stored, and ready to transport. Its
large storage capacity accommodates a wide variety of tools and accessories.

Adjustable dividers inside the toolbox allow you to customize the storage compartments to fit your specific requirements.
Dividers can be raised and fastened into place whenever needed, then unfastened and lowered when a larger storage area
is desired.

A zippered cover helps protect your tools from dust, debris, and moisture. When not needed, the cover can be rolled back­ward and stored in the pocket located on the back side of the toolbox.

Before using the toolbox for the first time, some minor assembly is required.

ASSEMBLING THE TOOLBOX:

See Figures 1 - 8.

n Raise the toolbox frame’s end panels until they are stand-

ing upright.

TOOLBOX

FRAME

END PANEL

END

PANEL

Fig. 1

n Lower the fabric body over the toolbox frame.

FABRIC

BODY

n Insert the toolbox handle through the vertical opening

located on the end panel of the toolbox frame.

HANDLE

Fig. 3

n Thread handle through the sleeves in the center divider

section and seat in the vertical opening on the opposite
side of the frame.

SLEEVES

LOOP(S)

TOOLBOX FRAME

n Pull the shoulder strap loops through the openings in the

fabric body.

Fig. 2

Fig. 4

n Secure the handle to the toolbox frame using the end

caps provided. While holding the handle firmly, seat end
cap on handle end and apply pressure until it snaps into
place. Repeat with other end cap.

END
CAP

Fig. 5

n Attach the shoulder strap clips to the loops located on

both ends of the toolbox.

LOOP(S)

CLIP(S)

n The toolbox cover is designed to be conveniently stored,

while remaining accessible. To store the cover, simply
unzip completely, then roll the cover backward and in­sert into the pocket located on the back of the toolbox
as shown. The hook-and-loop fasteners located on the
inside of the pocket and on the cover itself allow the cover
to be secured inside the pocket.

TOOLBOX

COVER

HOOK-

AND-LOOP

FASTENERS

SHOULDER STRAP

n To carry the toolbox when the cover is zipped closed,

simply lift the handle access flap as shown below and
grasp the toolbox handle.

HANDLE

ACCESS FLAP

Fig. 6

Fig. 7

POCKET

Fig. 8

WARNING:

To prevent possible serious injury, do not sit or stand on
the toolbox.

WARNING

To avoid possible back or lifting injury, use proper lift­ing techniques and do not attempt to lift an excessive
amount.

WARNING

If carrying a loose battery pack, keep it away from paper
clips, coins, keys, nails, screws, or other small metal
objects that can make a connection from one terminal
to another. Shorting the battery terminals together may
cause sparks, burns, or a fire.

983000-567
6-6-06 (REV:01)

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625

Phone [phone]

www.ryobitools.com

Always mention the model number when communicating with us regarding this product.