Russound SPG User Manual

LIMITED WARRANTY
The Russound SPG is fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. During this period Russound will replace any defective parts and cor­rect any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner’s expense and with prior written permission. Accidental damage and shipping damage are not considered defects under the terms of the warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to improper use voids the warranty. In these cases the repair will be made at the owner’s expense. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit.
5 Forbes Rd. Newmarket, NH 03857, USA
603.659.5170 • Fax 603.659.5388
e-mail: tech@russound.com
Come visit us at:
PAGING MODULE
PUSH TO TALK
MICROPHONE
System Paging Keypad
SPG
Instruction Manual
Conforms to UL 6500 Certified to CAN/CSA E65-94
SPG
INTRODUCTION
The SPG System Paging Keypad works with Russound’s Multi-Source, Multi­Zone Preamps. The SPG Paging Module provides “Push-to-Talk” paging oper­ation.
FUNCTIONS
Russound Preamps are equipped with multiple paging inputs. They are con­figured to page to all zones (except the zone where the page originates) at the preset volume level (if set) or half volume (if no volume level is stored into memory). The preamp’s paging feature is also configured to automati­cally turn on zones which may be turned off, as well as any equipment attached to the AC switched outlets or 12V triggers when a page is active.
Some models contain a “Page All” input as well. Using this input allows you to page all zones including the zone where the page originates.
CONNECTIONS
Use 22-24 AWG 4 conductor twisted pair shielded wire to connect the SPG to the page input as shown in the diagram below.
NOTE: Use only UL/CSA approved junction box.
12+TGR SICGND
4 CONDUCTOR TWISTED
PAIR SHIELD
Connect Shield to Ground (G)
VGS T
12+ SIC GND TGR
PAGE INPUT
Russound
Tested to Comply
with FCC Standards
FOR HOME OR OFFICE USE
Loading...