Russound ISK3 User Manual

ISK3 Door Station
Instruction Manual
Product Overview
The ISK3 Door Station is a flush-mounted weatherproof call station for the ComPoint™ intercom system. It features an amber-backlighted Call button and a solid metal cover plate available in three finish options.
The device fits a single-gang deep wall box and features doorbell contacts and an installer-adjustable control for the speaker volume level.
The ISK3 is environmentally tested for resistance to salt water spray and ultraviolet light.
5 Forbes Road, Newmarket NH 03857 USA
Tel 603.659.5170 • Fax 603.659.5388
www.russound.com
Warranty
The Russound ISK3 Door Station is fully guaranteed for two (2) years from the date of purchase against all defects in materials and workmanship. For this war­ranty to apply, the unit must be installed and used according to its written instructions. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. Accidental damage and shipping damage are not considered defects under the terms of this warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. If service is necessary, it must be performed by Russound. Damage to or destruction of components due to excessive power voids the warranty. In these cases, the repair will be made at the owner’s expense. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient mate­rial to protect the unit from damage in transit.
Before returning a unit for repair, call Russound at 603.659.5170 for a Return Authorization number. Write the RA number on the shipping label and ship to: Russound, 5 Forbes Road, Newmarket NH 03857.
Russound sells product only through authorized dealers and distributors to ensure that customers obtain proper support and service. Any Russound prod­uct purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sellers will not be honored or serviced under exist­ing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the appli­cable product.
Safety Precautions
For your safety, please read and follow these precautions before installing or using this product:
Read instructions. Read and understand all the applica-
ble instructions before installing or operating the product.
Retain documents. Keep this manual in a convenient
place for reference.
Heed warnings. Be aware of all warnings on the prod-
uct and in the instructions.
Follow instructions. Install and use this product only as
described in the instructions. Don’t try to use this prod­uct in ways it wasn’t designed for.
Avoid heat. Locate the product away from heat sources
such as radiators, heat registers, stoves or other appli­ances that produce heat.
Use the right power. Don’t connect the product directly
to electrical line voltage. Use only the power adapter pro­vided with the product, described in the product specifi­cations or installation instructions, or as marked on the product.
Ground product properly. Make sure the product’s
means of grounding or polarization is not defeated.
Keep product clean. From time to time, wipe off the
product with a clean soft cloth. Don’t use abrasive mate­rials, thinners, alcohol or other chemical solvents or materials.
Avoid spills and foreign objects. Make sure liquids
and objects don’t get into the product through any open­ings.
Get professional service. Have the product serviced
only by qualified service personnel when:
• Liquids have spilled or objects have fallen into the product
• The product doesn’t appear to operate normally
• The product is damaged
Don’t attempt to service the product yourself. Doing so will void the warranty.
If you have any questions, call Russound at 1-800-638-8055 or 603-659-5170.
Technical Specifications
User control: Call button with amber backlight
Audio input: Built-in microphone with automatic
gain control
Amplifier: Monaural (for system functions only)
Amplifier power: 2 watts
Volume control: Installer-adjustable potentiometer
Audio output: Built-in speaker
Cover plate: Weatherproof plated die-cast zinc
CAT-5 connector: 110 punch-down block
Doorbell connector: 2-pole screw terminal
Doorbell wire size: Up to 18 AWG (1.024 mm)
Doorbell contact: 1 A @ 12 VDC
Power consumption: 15 VDC 220 mA maximum
Dimensions: 3” W x 5.125” H x 3.25” D
(7.6 x 13.0 x 8.3 cm)
Wall box required: Single-gang, 22 cu in (360 cm
2
) min
Weight: 8 oz (227 g)
1
2
3
1
2
3
MICROPHONE AND SPEAKER – Support two-way com­munication with interior keypads
CALL BUTTON – Rings doorbell and initiates communi­cation
WEATHERPROOF COVER PLATE – Protects internal circuits and components
Copyright © 2007 Russound. All rights reserved. All trademarks are the property of their respective owners. Specifications are subject to change with­out notice. Russound is not responsible for typographical errors or omissions.
28-1214 Revision 1 04/13/07
When running CAT-5 and control cables, avoid running them near AC power wiring as much as possible. If you have to run the cables parallel to electrical wiring, space the cables at least two feet (0.6 m) from the AC power lines.
Connections
The door station provides a 110 punch-down connector for the CAT-5 cable. Use a punch-down tool to connect the wires according to the connector color code as shown below.
To connect a separate doorbell system, connect the 2-con­ductor cable to the doorbell terminals on the back of the door station as shown in the example below. The terminals provide access to normally open switch contacts that close for a minimum of 4 seconds when the Call button is pressed. Connect the cable from the ISK3 to the doorbell according to the doorbell system instructions.
1
2
3
ISK3 Door Station rear
CAT-5 connection
Connection to typical doorbell system
3
4
4
2
1
POTENTIOMETER – Adjusts speaker volume
110 PUNCH-DOWN BLOCK – For CAT-5 connection
SCREW TERMINALS – For external doorbell connection
WEATHERPROOF GASKET – Seals out moisture
Installation and Trim
The ISK3 Door Station installs in a standard single-gang US electrical deep plastic wall box with an internal volume of at least 22 cubic inches (360 cm3). With its own gasketed weather-resistant front plate, it needs no other protection.
Wiring
ComPoint system components interconnect with CAT-5 cable. Run CAT-5 from the hub location to each door station location. If you are installing optional ISDR1 Door Strike Release Modules, loop the door station cables through the module locations.
To use a separate doorbell system instead of the doorbell built into the ComPoint system, run 2-conductor cable from each door station to the doorbell system.
Speaker Volume Adjustment
Use the potentiometer to adjust the speaker volume. Turn it clockwise to raise the volume or counterclockwise to lower it. This does not affect the microphone sensitivity.
Operation
Press and release the Call button to ring the doorbell. When a person inside replies from a keypad, you will hear a single beep when they begin the reply and again when they’re done speaking. You then can answer the reply within 7 sec­onds by just speaking. At the end of the 7 seconds, you will hear a double beep, after which you can no longer answer the reply.
Note:
Pressing and releasing the Call button always rings the doorbell. To answer a reply, just speak without pressing the Call button.
You will hear a buzz tone from the door station when the person inside activates the door strike release.
Available Accessories
AWCAT5 4-pair, 24-gauge solid copper CAT-5e cable,
1000’ (305 m)
S1-22-R Single-gang deep plastic wall box with captive
mounting nails, 22 cu in (360 cm
2
)
ISDR1 Door Strike Release Module
BR BR/W G G/W O O/W BL BL/W
Doorbell
Transformer
Doorbell
Loading...