IRB-1
IR RECEIVER CONNECTION
Instruction Manual
Product Overview
The IRB-1 provides an effective in-wall method to connect tabletop infrared receivers.
IMPORTANT – Read the manuals that are included with the IR
receivers and other IR equipment you intend to install with the
IRB-1. It is important that you are familiar with the connection
and operation of these devices. If you are unsure of any of the
following installation procedures, this product should be
installed by a professional custom installer.
IR System Connections
1) Run 22 gauge, 3 or 4 conductor, shielded cable with drain
wire, such as Russound Pt. No. AW2260AB, into a standard
electrical junction box as shown in Figure 1.
2) Make sure that the IR system’s power source is not
connected.
3) Connect the wire to the +V, GND and SIGNAL (SIG) connections of the IRB-1 as shown in Figure 1. Please note that the
STATUS connection does not need to be connected.
4) Connect the other end of the wire to the IR system’s main
connecting block, such as Russound Pt. No. IRB-6, as shown
in Figure 1. Make sure that the drain wire of the cable is connected to the GND terminal of the input connector on the IR
system’s main connecting block. The drain wire does not
need to be connected to the ground connection of the IRB-1.
2
CONFIRM
IRB-1
CONFIRM
848
J-BOX
RECEIVER
22 AWG
4 Conductor
Sheilded
Cable w/ Drain
drain wire
connected
to GND
terminal
IRB-6
V+
GND
SIG
+12V
GND
OUT
+V
GND
SIG
Figure 1
IR RECEIVER CONNECTION
844 TABLE TOP RECEIVER
IR Receiver Connections
1) Connect the 3 conductor 1/8" plug of the tabletop IR receiver, such as Russound Pt. No. 844, to the 1/8" jack located on
the front of the IRB-1 as shown in Figure 2.
2) Following the instructions that came with your IR receiver,
place the IR receiver in a suitable location.
Installation
1) Check all connections, and proper system operation before
installing the IRB-1 into the wall.
2) Using the included hardware, install the IRB-1
into a standard electrical box.
Figure 2
3
Limited Warranty
The Russound IRB-1 is fully guaranteed for Two (2) years from the date of
purchase against all defects in materials and workmanship. During this
period Russound will replace any defective parts and correct any defect in
workmanship without charge for either parts or labor. For this warranty to
apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit
must be returned to Russound at the owner’s expense and with prior writ-
ten permission. Accidental damage and shipping damage are not considered defects under the terms of the warranty. Russound assumes no
responsibility for defects resulting from abuse or servicing performed by
an agency or person not specifically authorized in writing by Russound.
Damage to or destruction of components due to improper use voids the
warranty. In these cases the repair will be made at the owner’s expense. To
return for repairs, the unit must be shipped to Russound at the owner’s
expense, along with a note explaining the nature of the service required.
Be sure to pack in a corrugated container with at least 3 inches of resilient
material to protect the unit from damage in transit.
5 Forbes Rd. Newmarket, NH 03857, USA
☎ 603.659.5170 • Fax 603.659.5388
e-mail: tech@russound.com
Come visit us at:
4
Loading...