Russell Hobbs RHVTD1 (White), RHVTD2 (Silver) Instruction Manual

VENTED TUMBLE DRYER
INSTRUCTION MANUAL
RHVTD1 (White) & RHVTD2 (Silver)
Please read these instructions carefully and keep them for future reference
Model numbers:
TECHNICAL DATA
OVERALL DIMENSIONS:
Height: 85 cm Width: 59.5 cm Depth: 58 cm
MAXIMUM DRY WEIGHT LOADS:
Cotton 6kg (For minimum creasing 2kg) Delicates 2kg For electrical ratings see plate on back of dryer. For Model No. see serial plate inside door (needed when requesting service). Room temperature range 5˚C to 30˚C. Your washing machine should have a spin speed of not less than 800rpm.
IMPORTANT USER INFORMATION
This tumble dryer is intended for NORMAL DOMESTIC USE ONLY. Adequate ventilation must be provided to avoid back flow of gases into the room from
appliances burning other fuels. Including open fires.
Exhaust air must not be discharged into a flue which is used for exhausting fumes from
appliances burning gas or other fuel.
Please note it is not recommended that the dryer is placed directly next to ovens or
cookers as the performance of the dryer may be affected.
A carpet must not obstruct the ventilation openings in the base of the dryer. Do not stack the tumble dryer on top of other appliances without the correct stacking kit. Any electrical work required to install the appliance should be carried out by a qualified
person.
It is important to clean the lint filter after each drying cycle or the restrictions to airflow will
extend drying times and could cause the safety cut-out to trip.
Under no circumstances should anything other than the recommended articles be placed
in the tumble dryer.
The tumble dryer should be serviced by an appointed service organisation and only
genuine parts used.
It is dangerous to alter or modify the product in any way other than fitting authorized
accessories.
We recommend that the appliance is unplugged each time after use. It should always be
disconnected from the electricity supply or long periods (i.e.weekends, holidays etc.)
The rear of the dryer gets quite hot during use. Position the dryer so that the back is not
accessible while in operation, but ensure that the sides have a space available to allow airflow.
The special mains cable and plug assembly must only be replaced with a genuine part
from the manufacturer or our appointed service agent.
It is important to clean fluff from the window of the dryer and around the door seal after
each drying cycle. Failure to do so could result in water leaking.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
- Pull the filter upwards and away from the appliance.
- Remove any threads or fluff by hand or with a soft brush.
- Slide the filter back.
- Wash the filter occasionally in detergent solution using a soft brush to remove small particles.
- If your filter becomes damaged, replace it to ensure no damage is caused to the dryer.
person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
WARNING: Never stop a tumble dryer before the end of a drying cycle unless all items are quickly removed and spread out so that heat is dissipated. Remove all objects from pockets such as lighters and matches. DO NOT use a two-way adaptor, or extension lead. The dryer must be connected to its own socket.
DO NOT block the air inlets at the front, base, rear and side of your dryer. DO NOT allow fluff to accumulate around the tumble dryer. Risk of fire DO NOT exceed the recommended maximum load. DO NOT dry unwashed items in the tumble dryer DO NOT place articles in the dryer if anything other than a water solution has been used in the
cleaning process.
DO NOT attempt to dry dripping wet articles. DO NOT use the tumble dryer if you suspect that it is damaged in any way. Under no
circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause serious injury. Consult your local appointed service engineer and insist on genuine spare parts.
THIS APPLIANCE MUST BE EARTHED
This label, positioned on the rear of your dryer, indicates the surface is hot when in operation – avoid touching
CAUTION
HOT SURFACE NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM.
RISK OF FIRE. ALWAYS CLEAN THE FILTER AFTER EACH USE. Failure to do so could cause the safety
cut-out to operate.
Loading...
+ 6 hidden pages