Russell Hobbs 9919 Instructions And Guarantee

Classic White

Juice Centre

Model No. 9919

Instructions and Guarantee

Read these instructions before using your Classic White Juice Centre and keep
them in a safe place for future reference. If you pass the gadget on to anyone
else, you should also pass on the instructions.
Remove all packaging before using the product, but keep the packaging until you
are satisfied that the product is operating correctly.
You may find a plastic label on the outside of the product, listing its features.
This must be peeled off before use.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:

1. In common with other portable electrical appliances this product
must never be put in water, used in a bathroom or used near any
source of water. Do not use outdoors.

2. Switch off (power switch out) and unplug from the power socket
before dismantling or cleaning.

3. Use the pusher to push food down the chute, do not use fingers,
cutlery, or anything else.

4. Switch off (power switch out) and wait until the grating sieve has
come to a complete stop before removing the cover from the
juice extractor.

5. The motor unit incorporates a microswitch which will prevent the motor from
operating unless the juice extractor cover or the citrus press gearbox housing
is fitted. Do not attempt to use the appliance without one of these in place.

6. Do not use the juice extractor if the grating sieve is damaged.

7. Do not allow children to use the juice extractor or citrus press without
constant supervision by a responsible adult.

8. Position the motor unit on a dry, firm, level surface, close to a power socket
which is out of reach of children.

9. Route the mains lead so that it does not overhang a working surface, and
cannot be tripped over or caught accidentally. Push any excess mains lead
into the cord storage area in the back of the motor unit.

10. Close supervision is necessary when any appliance is used near children.

11. Do not let the mains lead touch any hot surfaces.

12. Do not wrap the mains lead around the juice extractor, use the cord storage
area in the back of the motor unit.

13. Store the juice centre away from direct sunlight and fluorescent light, where
possible, as prolonged exposure to ultraviolet may discolour the plastic casings.

14. Do not let the juice container overflow. If liquid gets under the unit, it may
be sucked into the motor, damaging it.

15. Do not run the motor continuously for more than 2 minutes, otherwise it may
overheat. After 2 minutes it must be switched off for at least 2 minutes
before running it again, to allow it to recover.

16. To avoid overheating, do not run the juice extractor empty, switch it off.

17. Do not operate this appliance after it malfunctions or if the mains lead or
plug is damaged. There are no user-serviceable parts. The appliance must be
returned for repair or replacement in order to avoid hazard (see “AFTER
SALES SERVICE”).

Household use only

2

DANGER

Electric

Shock Risk

3

Juice Extractor

Pages 4 to 6

Citrus Press

Pages 4, and 7 to 9

THE CONTROLS

Accessory lock
Pressing the accessory lock down (towards RELEASE) retracts the locking pins at
the front and rear of the motor unit, to allow the juice extractor or citrus press
to be fitted or removed.
The motor will not function unless one of the accessories (juice extractor or
citrus press) is attached to the motor unit.

Speed switch

This controls the motor speed. Press and release the left side (I) of the speed
switch for low speed, press and release the right side (II) for high speed.
When using the citrus press, set the switch to low speed (I).
When using the juice extractor, set the switch to
low speed (I) for soft fruits and vegetables, and
berries. Set it to high speed (II) for hard fruits and
vegetables.
Set the speed before operating the power switch.

Power switch

This switches the motor on and off. It is a “Press­on/Press-off” switch. In the “Off” position, it
comes out flush with the surface of the speed
switch, in the “On” position, it is depressed.
To switch on, first set the operating speed with the
speed switch, then press and release the power switch. The switch will remain
in the depressed position, one of the indicator lights will come on, depending on
how you set the speed switch, and the motor will start.
To switch off, press and release the power switch again. The switch will pop out,
the indicator light will go out, and the motor will stop.

THE JUICE EXTRACTOR
Assembly

1. Switch off (power switch out) and unplug the motor unit from the power socket.

2. With the pulp container to the left of the motor unit, lower the separator/pulp
container on to the motor unit so that it sits over the drive wheel.

3. Place the grating sieve inside the separator, and turn it slightly, to allow it to
engage with the drive wheel.

4. Press the safety lock down towards “RELEASE”, and hold it down.

5. Lower the cover on top of the separator.

6. Let go of the safety lock. The locking pins will engage in the slots in the
front and back of the cover, to secure it.

7. Place the juice container under the spout.

8. Turn the feed tray over and fit it on top of the chute.

9. Place the pusher in the chute.

4