Page 1
C
DIAMETER
A
B
HOT
WATER
CONNECTION
COLD
WATER
CONNECTION
ANODE
ROD
RELIEF VALVE
CONNECTION
8"
WATER CONNECTIONS ALL 3/4" N.P.T.
Imperial Rheemglas
®
Available in 40, 50, 65, 80 Gallon Models
10-Year Limited Tank and Parts Warranty*
®
Energy Miser®HIGH EFFICIENCY Electric Water Heater
High performance and recovery
•
Patented R-Foam®insulation
•
Brass drain valve
•
EverKleen™self-cleaning device
•
Lifeguard™high efficiency stainless
•
steel elements
Temperature and pressure relief
•
Automatic thermostat keeps water at
•
desired temperature
Compliant with many electric utility
•
incentive programs
Meets or exceeds requirements of the
•
National Appliance Energy Conservation
Act (NAECA)
valve included
Isolated tank design reduces conductive
•
heat loss
Premium grade
•
anode rod equalizes
aggressive water action
Electric junction box located above
•
heating elements for easy installation
Over-temperature protector cuts off power
•
in excess temperature situations
ESCRIPTION FEATURES ROUGHING IN DIMENSIONS (SHOWN IN INCHES) ENERGY INFORMATION
D
T
Y
GAL. FIRST HOUR IN G.P.H. HEIGHT WATER CONN. DIAMETER SHIP WT. ENERGY ANNUAL
P
AP. MODEL NUMBER RATING G.P.H. @ 90° RISE AB C(LBS.) FACTOR OPER. COST
C
E
40 83XR40-2 55 21 46-3/4 46-3/4 22-1/4 100 0.95 $492
T
50 83XR52-2 67 21 57 57 22-1/4 118 0.95 $492
A
L
65 83XR66-2 71 21 58-3/4 58-3/4 23 160 0.92 $508
L
80 83XR80-2 88 21 59 59 24-1/2 180 0.92 $508
50 83MXR52-2 63 21 46 46 24-1/4 130 0.93 $503
MED.
• Heaters furnished with standard 240 volt AC, single phase non-simultaneous wiring, and 4500 watt upper and lower heating elements.
• If heating elements of different wattages than those shown are demanded by zone requirements, they must be specifically
requested.
• Special Wiring Options – A limited number of special wiring options are available. Consult factory for price and availability.
• All models equipped with heat traps.
RECOVERY TANK HEIGHT TO APPROX. AVERAGE
*See Residential Warranty Information Brochure for complete
warranty information.
nergy Factor and Average Annual Operating
E
osts based on D.O.E.(Department of
C
nergy) test procedures. D.O.E. national
E
verage fuel rate electricity 10.65¢/KWH.
a
Recovery = wattage/2.42 x temp. rise °F.
Example:
4500W
2.42 x 90°
= 21 GPH
These units are designed
to meet or exceed ANSI
(American National Standards
Institute) requirements and
have been tested according
to D.O.E. test procedures and
meet or exceed the energy
efficiency requirements of
NAECA, ASHRAE standard 90,
ICC Code and all state energy
efficiency performance criteria
for energy consuming
appliances.
Before purchasing this
appliance, read important
energy cost and efficiency
information available from
your supplier.
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
Lifeguard™Electric Element
High density nichrome wire electric
heating filament; best grade A, 80/20
nichrome wire made…for top
performance and long-life operation.
High-grade magnesium oxide
packing moves the heat
quickly to the element’s
surface, protecting the
nichrome wire filament and
boosting efficiency.
Steel screw-in head
provides solid construction
and ease of maintenance.
INCOLOY®840 stainless steel sheath,
resists water chemical corrosion and
burn-out even in air or sediment for
long element life, long life performance.
Low watt density design delivers
full watt-rated heating power to
a larger surface area, eliminating
high heat concentrations and
prolonging element life.
Rheem Water Heating • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.rheem.com
P R I N T E D I N U . S . A 1 1 / 0 9 WP F O R M N O. 10 1 - 1 9 R ev . 2
Loading...