DS 2
Instruction manual
DS 2
EN
1
Please take time to read this manual carefully before operation.
Persons who are not familiar with this manual should not use this
dehumidifier.
We strongly recommend keeping this manual in a safe place for future
reference.
Page
Specification 2
How it works 3
Where to position 4
Before use 5-8
Parts 9
Programming features 10-11
Operation 12-13
Drainage 14-15
Maintenance 16
Trouble shooting 17
Contents
2
Disposal
This product should be taken to our local recycling centre for
safety treatment. Waste electrical and electronic products must
not be disposed of with household waste.
Specification
Above is measured under RT 30 oC , RH 80%.
The data marked with * may vary for technical reasons. For greater
precision, please refer to the rating label placed on the product.
Current & Fuse : F2L250V or T2L250V
3
This is a compressor free dehumidifier which operates without refrigerant.
It has an almost consistent rate of water extraction at all temperatures and
is more efficient than compressor based dehumidifiers when used at low
temperatures below 5°C.
The operation theory exists in the Dehumidify Wheel (a chemically
impregnated rotating wheel). Damp air from the environment is drawn
through the unit where it comes into contact with the wheel. The chemical
on the wheel removes the moisture from the air and warmed by the heating
elements inside.
As the wheel rotates to a different position, the heater drives the water from
the chemical wheel and the water is condensed through heat exchange
system and removed to water tank.
How it works
4
Excess moisture will
travel throughout your
home, For this reason,
the dehumidifier should
be positioned, so that
it can draw this moist
air towards it from
all over the home.
When positioning the
dehumidifier, ensure
that it is placed on a
level surface and that
there is a minimum of
20 cm (8") of space on
either side of the unit
to allow for efficient
airflow. Heater advice
for Dryer function. The
distance between air
vent & clothes must be
kept at least 40cm to
avoid water drop into
machine and cause
damage.
Suitable to use in basement, kitchen, living room etc.
Where to position
5
Before use
Caution!
Operate this unit on a firm, flat surface to avoid water leak. Ensure that
it is kept upright at all times (including transport and store).
Do not place on soft surfaces.
Ensure that there is at least 300mm between the sides of the appliance
and any flammable materials.
Ensure that there is at least 900mm from the top of the appliance and
any flammable materials.
The unit contains a chemical substance. The unit will emit a
chemical smell during the 1st hour of operation without any dangerous
consequences.
The unit features an anti-tip safety device that will switch the unit off if it
was tipped during operating.
Only connect the unit to a properly installed and easily accessible socket
so that you can quickly pull the plug in an emergency.
DO NOT OBSTRUCT THE AIR INTAKES AND EXHAUSTS.
FOR INDOOR USE ONLY.
DO NOT EXPOSE THE UNIT TO DIRECT SUNLIGHT.
DO NOT USE IN CABINET, CLOSET, BOATS, CARAVANS OR
SIMILAR LOCATIONS.
DO NOT USE THE UNIT IN BATHROOMS, SWIMMING POOLS,
WASHROOMS OR SIMILAR WET AREAS.
DO NOT USE THE UNIT CLOSE TO A BATHTUB, SHOWER, SINK
AND THE LIKE.
Do not use the appliance in locations where paint, petrol or other
flammable liquids are used or stored.
6
Do not allow the appliance to fall over when there is water in the bucket.
AVOID THE UNIT FROM SPLASH. DO NOT LET ANY LIQUID ENTER
THE UNIT.
DO NOT PLACE A CONTAINER WITH LIQUID ON TOP OF THE UNIT.
THE CONDENSED WATER IS NOT FOR DRINKING EITHER FOR
HUMAN OR ANIMALS.
DO NOT USE BUG SPRAYS OR OTHER FLAMMABLE CLEANSERS
ON THE UNIT.
Do not lay the cord under carpets/rugs so that you can regularly check
its condition.
DO NOT TOUCH THE PLUG OF THE UNIT WITH WET HANDS.
Never use the cord of the unit as a carrying strap.
Before moving the unit, first switch off, then unplug and empty the water
tank. Basically, it takes around 2 minutes to stop the unit and this allows
the heater to cool down.
Always unplug the unit from the mains and wait for at least one hour
before carrying out any maintenance, transport or cleaning of the unit.
Always switch the unit off and pull the plug out of the socket:
If you are not using the unit.
Before you clean the unit.
Before you assemble the accessories.
If a fault occurs.
In the event of a storm.
AVOID OVER-TWISTING, -COILING, -PULLING THE POWER CORD,
NEVER USE NYLON OR IRON WIRE TO TIDE THE POWER CORD.
¥
¥
¥
¥
¥
7
DO NOT USE EXTENSION CORDS.
IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY
AN ELECTRICIAN OR SIMILARLY QUALIFIED PERSON, TO AVOID
HAZARD.
THE MAINS SUPPLY MUST CONFORM TO THE SPECIFICATION
SHOWN ON THE RATING PLATE AT THE BACK OF THE UNIT.
THE APPLIANCE SHALL BE INSTALLED IN ACCORDANCE WITH
NATIONAL WIRING REGULATIONS.
NEVER REACH TO RETRIEVE THE UNIT IF IT HAS FALLEN IN
WATER. IN SUCH CASE, IMMEDIATELY PULL THE PLUG. HAVE THE
UNIT CHECKED BEFORE USING IT AGAIN.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS
(INCLUDING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE
AND KNOWLEDGE , UNLESS THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CONCERNING USE OF THE
APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO
NOT PLAY WITH APPLIANCE.
SUGGEST TO SEND THE UNIT FOR PROFESSIONAL
MAINTENANCE PERIODICALLY.
ONLY A LICENSED PROFESSIONAL IS ALLOWED TO DISMANTLE
OR MODIFY THE APPLIANCE.
8
DO NOT USE YOUR DESICCANT UNDER THE FOLLOWING:
9
Parts
10
Programming Feature
1. MODE BUTTON By pressing this button, you can set the working
mode of the machine to be:
LOW (MUTE dehumidifying): When the ambient humidity < set
humidity, the unit will run in LOW fan speed (without Heater).
:KHQWKHDPELHQWKXPLGLW\VHWKXPLGLW\WKHXQLWZLOOUXQLQ/2:
fan speed & WITH Heater.
HIGH785%2GHKXPLGLI\LQJ:KHQWKHDPELHQWKXPLGLW\VHW
humidity, the unit will run in HIGH fan speed & WITH Heater.
When the ambient humidity < set humidity, machine will run in
HIGH fan speed (without Heater).
DRYER: ALWAYS ON with HIGH fan speed and HEATER.
2. HUMIDITY BUTTON
• Press HUMIDITY button to set the room humidity you need: continuous
dehumidifying , 40%, 50%, 60% or 70% The relative indicator will light
on.
• If the humidity button is not set, the unit will work in the pre-set
humidity: 50%.
Loading...