ROTRONIC CF5-W User Manual

Dokument
IMA 206

Rev 1 Page
1 (4)

3

2

5

1

4

1

1 top part

Installation manual

CF5-W, CF5-W-Disp

Dismounting of the sensor

2 front part
3 wall plate
4 screw
5 label with
settings
inside the
top part

Pull the top part upwards

Push the front part upwards while Fold the front part forwards and
keeping the wall plate steady loose it from the hooks (#1)

Dokument
IMA 206

Rev 1 Page
2 (4)

+

~

A

B

The screw head diameter should be max 7,5 mm

max 2,5 mm

Mounting of the sensor

The wall plate is screwed onto the wall (A) Put the top tabs of the front part into the top
holes of the wall plate.
(B) Press the lower edge of the case onto
the wall plate to latch

If the connection cables are drawn through a conduit the conduit must be
sealed.
Air of different temperature may otherwise disturb the temperature
measurements.

The screw head height should be

The top part is pushed under the Terminals and jumpers on CF5-W.
locking hooks of the wall plate The darker positions are default settings.
and is secured with a screw Terminals and jumpers are located under the top part.

If for some reason the PCB must be removed it must be handed carefully
and protected from electrostatic discharge! Normally, removing the PCB is

not required.