Rose Displays SUPERSNAP WITH ANOCONNECTORS User Manual

SuperSnap™ with AnoConnector

Instruction Sheet

Parts

SuperSnap

12S300

Instructions for assembly

Step 1

Slide MultiClip into top of the
SuperSnap. Holding clip at a slight
angle, first insert one round end,
then press down on other round
end and push MultiClip into
position. Fig. 1 & 2

Note: Position MultiClip about
halfway down each SuperSnap. Fig. 3

Step 2

Insert AnoConnector into rail of one
SuperSnap. Make sure tabs face
upward. The side with one tab must
go in first. Fig. 4

Multi Clips

1UP-0100

Figure 1

Figure 3

6” Rod

97-0304-06

AnoConnector

06-2930

Figure 2

Step 3

Insert threaded rod halfway into clip
rail of the same SuperSnap. Fig. 5

Step 4

Push the second piece of SuperSnap
onto both AnoConnector and the
threaded rod. Push together until
both holders meet. Fig. 6 Repeat
steps 2-4 for additional SuperSnaps.

Page 1 of 2

The SuperSnap and AnoConnector are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSSuperSnapAnoConnector

Incept-9.12.02

Figure 5

Figure 4

Figure 6

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

SuperSnap™ with AnoConnector

Instruction Sheet

Parts

SuperSnap

12S300

Instructions for assembly

(continued)
Step 5

Snap all sections of the SuperSnap
open. Fig. 7

Note: It is easier to open and close the
SuperSnap by starting at one
end and working your way down
the holder.

Step 6

Insert graphic into one section of
SuperSnap (top and bottom). Fig. 8

Step 7

To close, snap the SuperSnap shut.

Fig. 9

Step 8

You should now have one graphic in
place. Repeat steps 5-7 for hanging
additional graphics.

Step 9

Push end caps into place. Fig 10

Multi Clips

1UP-0100

Open all holders

6” Rod

97-0304-06

AnoConnector

06-2930

Figure 8Figure 7

Figure 10Figure 9Insert posters

Step 10

Suspend holders. Finished Look

Important note:

Please save and reuse the
SuperSnap, End Caps, AnoConnectors,
and MultiClips for future projects.

Page 2 of 2

The SuperSnap and AnoConnector are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSSuperSnapAnoConnector

Incept-9.12.02

Finished Look

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]