Rose Displays SuperSnap with AnoConnector User Manual

SuperSnap™ with AnoConnector

Instruction Sheet

Parts

6” Rod

97-0304-06

CableClip

06-5050

SuperSnap

12S300

Instructions for assembly

Step 1

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 1

Align one round end of cable clip with top
channel of the rail and insert. Once in
place, insert end of ball chain into channel.
Then press down on the other round end of
the cable clip and slide into rail by pushing
on the clip. Fig. 2

Note: Be sure to push on the cable clip in
order to slide the ball chain into place. Do
not pull on, or push against, the ball chain
as this will cause it to bind in the channel.

Note: Position CableClip about halfway
down each SuperSnap. Fig. 3

Step 2

Insert AnoConnector into rail of one
SuperSnap. Make sure tabs face upward. The
side with one tab must go in first. Fig. 4

End Caps

06-5475

Figure 1

Figure 3

AnoConnector

06-2930

Figure 2

Ball Chains

96-0302P

Figure 4

Step 3

Insert threaded rod halfway into clip rail of
the same SuperSnap. Fig. 5

Step 4

Push the second piece of SuperSnap onto
both AnoConnector and the threaded rod.
Push together until
both holders meet. Fig. 6 Repeat steps 2-4
for additional SuperSnaps.

The SuperSnap™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSSuperSnapAnoConnectorCCBC

Incept-11.13.02

Figure 5

Figure 6

Page 1 of 2

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

SuperSnap™ with AnoConnector

Instruction Sheet

Parts

6” Rod

97-0304-06

CableClip

06-5050

SuperSnap

12S300

Instructions for assembly

(continued)
Step 5

Snap all sections of the SuperSnap
open. Fig. 7

Note: It is easier to open and close
the SuperSnap by starting at one
end and working your way down
the holder.

Step 6

Insert graphic into one section of
SuperSnap (top and bottom). Fig. 8

Step 7

To close, snap the SuperSnap shut.

Fig. 9

Step 8

You should now have one graphic in
place. Repeat steps 5-7 for hanging
additional graphics.

Step 9

Push end caps into place. Fig 10

End Caps

06-5475

AnoConnector

06-2930

Open all holders Figure 8Figure 7

Ball Chains

96-0302P

Figure 10Figure 9Insert posters

Step 10

Suspend holders. Finished Look

Important note:

Please save and reuse the
SuperSnap, End Caps and
CableClips for future projects.

The SuperSnap™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSSuperSnapAnoConnectorCCBC

Incept-11.13.02

Finished Look

Page 2 of 2

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]