Rose Displays SPIDER CEILING TRACK WITH ADHESIVE User Manual

Spider™ Ceiling Track

Parts

Spider™

Ceiling Track

with Adhesive

25-0027

Instructions for Hanging

Step 1

Clean ceiling area and mark location
for track on ceiling.

Step 2

Peel adhesive liner off Spider Track.

Instruction Sheet

Step 3

Place Spider Track on marked
ceiling location. Be sure it is
postioned correctly.

Step 4

Apply pressure along track for
1 minute, then allow adhesive to
cure for 1 hour before using track.

Note: Install OneUp anchors with
ladderless RoPole Installation Tool.

Figure 2Figure 1

Figure 3 Figure 4

The Spider Ceiling Track and RoPole are trademarks and OneUp is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these products. Part
#01INSSpider Track w/adhesive

Incept-5.30.01

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Parts

Instructions for Hanging

Step 1

Clean ceiling area and mark location
for track on ceiling.

Step 2

Peel adhesive liner off Spider Track.

Instruction SheetSpider™ Ceiling Track

Spider™

Ceiling Track

with Adhesive

25-0027

Step 3

Place Spider Track on marked
ceiling location. Be sure it is
postioned correctly.

Step 4

Apply pressure along track for
1 minute, then allow adhesive to
cure for 1 hour before using track.

Note: Install OneUp anchors with
ladderless RoPole Installation Tool.

Figure 2Figure 1

Figure 3 Figure 4

The SpiderTM Ceiling Track and RoPole are trademarks of and OneUp is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these products.
Part #01INSSpider Track w/adhesive

Incept-5.30.01