Rose Displays RAN-BAS-CC WITH LOOP AND BALL User Manual

Cable/Cord SpiderTM Anchor with Loop and Ball

Parts

Instruction Sheet

Spider Anchor
RAN-BASE-CC

Instructions For Hanging

Step 1

Push ball up through large hole in bottom of spider
anchor. Fig. 1

Step 2

Slide ball into pocket next to the hole. Pull cable
tight. Fig. 2

Step 3

Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 3

Loop and Ball

16-0018BL

Figure 1 Figure 2

Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri­ate instruction sheet.

The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #01INSLoop&Ball

Incept-10.15.01

Figure 3

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Cable/Cord SpiderTM Anchor with Loop and Ball

Parts

Instruction Sheet

Spider Anchor
RAN-BASE-CC

Instructions For Hanging

Step 1

Push ball up through large hole in bottom of spider
anchor. Fig. 1

Step 2

Slide ball into pocket next to the hole. Pull cable
tight. Fig. 2

Step 3

Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 3

Loop and Ball

16-0018BL

Figure 1 Figure 2

Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri­ate instruction sheet.

The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #01INSLoop&Ball

Incept-10.15.01

Figure 3