Rose Displays QUICKGRIP WITH PEGS AND MULTICLIPS User Manual
QuickGrip™ with Peg
2
242
Parts
Instruction Sheet
QuickGrip
12-0500
Instructions for Hanging
Step 1
When using QuickGrip to hang 1/8” Sintra
or an equally heavy substrate, have your
printer punch two 1/4” holes along the top
and bottom edges of print — or only the top
if no bottom holder is being used. Fig. 1
Note: Each hole must be centered 1/4” in
from the edge of the substrate.
Step 2
Push both parts of the peg together through
each of the punched holes. Fig. 2
Step 3
Slide QuickGrip onto substrate. The pegs
should slide into the side rails. Fig. 3
Note: This is the easiest way to safely hang
heavier substrates.
Step 4
Squeeze sides of MultiClip together. Fig. 4
Align the bottom rail of the MultiClip with
the top channel of the plastic holder. Slide
MultiClip into rail. Fig. 5 Repeat step 3
for second MultiClip.
Multiclips
1UP-0101
Figure 4
End Caps
06-5525
Pegs
06-1920
Figure 3Figure 2Figure 1
Figure 5
Step 5
Push end caps into place. Fig. 6
Step 6
Suspend poster. Fig. 7
QuickGrip is a trademark of Rose Displays, Ltd. Neither the manufacturer
nor any sales agent may be held liable for injury, loss or damage resulting
from the use of these products.
Part #03INSQuickGripPegMC
Incept-3.11.03
Tel# 1-800-631-9707 Fax# 1-800-560-2890
Figure 7Figure 6
35 Congress Street, Salem, MA 01945
e-mail:signware@rosedisplays.com
QuickGrip™ with Peg
2
242
Parts
Instruction Sheet
QuickGrip
12-0500
Instructions for Hanging
Step 1
When using QuickGrip to hang 1/8” Sintra
or an equally heavy substrate, have your
printer punch two 1/4” holes along the top
and bottom edges of print — or only the top
if no bottom holder is being used. Fig. 1
Note: Each hole must be centered 1/4” in
from the edge of the substrate.
Step 2
Push both parts of the peg together through
each of the punched holes. Fig. 2
Step 3
Slide QuickGrip onto substrate. The pegs
should slide into the side rails. Fig. 3
Note: This is the easiest way to safely hang
heavier substrates.
Step 4
Squeeze sides of MultiClip together. Fig. 4
Align the bottom rail of the MultiClip with
the top channel of the plastic holder. Slide
MultiClip into rail. Fig. 5 Repeat step 3
for second MultiClip.
Multiclips
1UP-0101
Figure 4
End Caps
06-5525
Pegs
06-1920
Figure 3Figure 2Figure 1
Figure 5
Step 5
Push end caps into place. Fig. 6
Step 6
Suspend poster. Fig. 7
QuickGrip is a trademark of Rose Displays, Ltd. Neither the manufacturer
nor any sales agent may be held liable for injury, loss or damage resulting
from the use of these products.
Part #03INSQuickGripPegMC
Incept-3.11.03
Tel# 1-800-631-9707 Fax# 1-800-560-2890
Figure 7Figure 6
35 Congress Street, Salem, MA 01945
e-mail:signware@rosedisplays.com
Loading...