Rose displays GOTCHA WITH V CLIP User Manual

Gotcha

Parts

®

Instruction Sheet

Gotcha

12G100

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the
Gotcha open and insert poster (top and bottom).
To close, snap the Gotcha shut. Fig. 1
Note: It is easier to open and close the Gotcha by
starting at one end, and working your way down
the holder.

Step 2

Insert Gotcha Clips into slot on backside of the
top Gotcha only. (You should hear a "SNAP"
when the clips are inserted properly). Fig. 2

Note: For best results, place the clips 1/3 of the
way in from each end on the top Gotcha holder.

Gotcha Clip

12G100

V Clip

12G100

Figure 1

Jet Wire

12G100

Step 3

Attach V Clip to ceiling grid.

Step 4

Attach one end of Jet wire to V Clips and the
other into the Gotcha clips. Fig. 2 & 3

Slowly pull sign down to desired level. Jet Wire
stretches to 48”.

Important note:

Please save and reuse the Gotcha Holder, V Clips
and Gotcha clips for future projects.

The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSGOVCLP

Incept-3.1.99

Figure 2

Figure 3

21 Lime Street, Marblehead, MA 01945

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Gotcha

Parts

®

Instruction Sheet

Gotcha

12G100

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the
Gotcha open and insert poster (top and bottom).
To close, snap the Gotcha shut. Fig. 1
Note: It is easier to open and close the Gotcha by
starting at one end, and working your way down
the holder.

Step 2

Insert Gotcha Clips into slot on backside of the
top Gotcha only. (You should hear a "SNAP"
when the clips are inserted properly). Fig. 2

Note: For best results, place the clips 1/3 of the
way in from each end on the top Gotcha holder.

Step 3

Attach V Clip to ceiling grid.

Gotcha Clip

12G100

V Clip

12G100

Figure 1

Jet Wire

12G100

Step 4

Attach one end of Jet wire to V Clips and the
other into the Gotcha clips. Fig. 2 & 3

Slowly pull sign down to desired level. Jet Wire
stretches to 48”.

Important note:

Please save and reuse the Gotcha Holder, V Clips
and Gotcha clips for future projects.

The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSGOVCLP

Incept-3.1.99

Figure 2

Figure 3

21 Lime Street, Marblehead, MA 01945

Tel# [phone] Fax# [phone]

e-mail:[e-mail]