Rose displays GIRDER GRIPPER User Manual

Girder Gripper

Components

™

Instructions

For open ceilings or truss beams

Girder Gripper

Omni Head

To install

Step 1

Assemble poster, sign holders, hook and Girder
Gripper. Seat in the Omni head. (Fig. 1)

Step 2

Rest the heel of the RoPole™ on floor. Loosen the
telescopic joints and extend the pole and assembly
to the ceiling. Lock the RoPole joints securely.

Step 3

Raise the Girder Gripper above the spot on the
beam where you want to hang the sign. Lower it
onto the beam. (Fig. 2)

Firmly pull the RoPole straight down.

To remove

Step 1

Rest the RoPole on the floor, extend to ceiling and
firmly lock the joints.

Step 2

Capture the bottom of the Girder Gripper with the
Omni head. (Fig. 3)

Step 3

Push Girder Gripper up and rotate 1/4 turn.
(Fig. 4)

Slowly lower the assembly.

Helpful hints

• Practice makes perfect!

• Those not yet familiar with the RoPole should
practice installing and removing the anchor from
the ceiling without a poster a few times first.

• Keep the RoPole vertical and directly beneath
the anchor.

OneUp

Double Hook

Figure 1

Girder Gripper with assembled
components in Omni RoPole™

OneUp Clip

Sign Holder

Figure 2

Girder
Gripper

Truss
beam

Omni Head

Figure 3

Capture
bottom
of Girder
Gripper

Figure 4

Girder
Gripper

Truss
beam

Omni
Head

The OneUp and the RoPole are patented and registered trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage
resulting from the use of these products.
GG-1000 6/95