ROHM DTC144WE Technical data

100mA / 50V Digital transistors (with built-in resistors)
DTC144WE / DTC144WUA / DTC144WKA
Applications Dimensions (Unit : mm) Inverter, Interface, Driver
Features
1) Built-in bias resistors enable the configuration of an inverter circuit without connecting external input resistors.
2) The bias resistors consist of thin-film resistors with complete isolation to allow negative biasing of the input, and parasitic effects are almost completely eliminated.
3) Only the on / off conditions need to be set for operation, making the device design easy.
4) Higher mounting densities can be achieved.
Structure NPN epitaxial planar silicon transistor (Resistor built-in type)
Packaging specifications
Part No. DTC144WE DTC144WUA DTC144WKA
Package Packaging type Code Basic ordering unit (pieces)
EMT3
Taping
TL
3000
UMT3
Taping
T106 3000
−−
−−
SMT3
Taping
T146 3000
Inner circuit
R
1
IN
R
2
OUT
GND
EMT3
(SC-75A) <SOT-416>
(1) GND (2) IN (3) OUT
UMT3
<SC-70>
(1) GND (2) IN (3) OUT
SMT3
<SC-59>
(1) GND (2) IN (3) OUT
1.6
0.3
(3)
0.8
(2)
0.2
(1)
0.2
0.5
0.5
1.0
Abbreviated symbol : 86
2.0
0.3
(3)
1.25
(1)
(2)
0.65
0.65
1.3
Abbreviated symbol : 86
2.9
0.4
(3)
(2)
0.95 0.95
Abbreviated symbol : 86
(1)
1.9
0.7
0.55
1.6
0.15
0.1Min.
0.9
0.7
0.2
2.1
0.15
1.6
2.8
0.15
0.1Min.
1.1
0.8
0.3Min.
IN
R1=47kΩ, R2=22kΩ
GND
OUT
www.rohm.com
1/2
c
2009 ROHM Co., Ltd. All rights reserved.
2009.06 - Rev.C
Absolute maximum ratings (T a=25C)
Parameter Symbol Supply voltage Input voltage
Output current Power
dissipation Junction temperature
Storage temperature
Electrical characteristics (Ta=25C)
Input voltage Output voltage
Input current Output current DC current Input resistance Resistance ratio
Transition frequency
Characteristics of built-in transistor
Electrical characteristic curves
100
50
) (V)
20
on
(
I
10
5
2 1
500m
INPUT VOLTAGE : V
200m 100m
100200500∝ 1m 2m 5m 10m 20m 50m 100m
Fig.1 Input voltage vs. Output current (ON characteristics)
500m
200m
) (V)
on
(
100m
O
50m
20m 10m
5m
OUTPUT VOLTAGE : V
2m 1m
1002005001m 2m 5m 10m 20m 50m 100m
Fig.4 Output voltage vs. Output current
DTC144WE DTC144WUA / DTC144WKA
Parameter Symbol Min. Typ. Max. Unit Conditions
I(off)
V V
I(on)
V
O(on)
I
I
I
O(off)
G
gain
V
O
=0.3V
Ta= 40°C
OUTPUT CURRENT : I
IO/I
I
=20/1
OUTPUT CURRENT : I
Ta=25°C
Ta=25°C
Ta=100°C
Ta=100°C
O
(A)
Ta= 40°C
O
(A)
I
R
1
R
2/R1
f
T
CC
V
V I
I
C(Max.)
P
I
O
D
10 to +40
Tj
Tstg
55 to +150
4 −−
0.1
56
32.9
47
Limits
50
30 100 150 200 150
0.8
0.3
0.16
0.5
61.1
V V
mA
μA
kΩ
Unit
V V
mA
mW
°C °C
V V I
O
V V I
O
CC
=5V, IO=100μA
O
=0.3V, IO=2mA
=10mA, II=0.5mA
I
=5V
CC
=50V, VI=0V
=5mA, VO=5V
0.37 0.47 0.57 −−
(A)
O
OUTPUT CURRENT : I
250
10m
V
CC
=5V
5m 2m
500 200
100
50 20
10
1m
5 2
1
Ta=100°C
Ta=25°C
0 500m 1 1.5 2 2.5 3
INPUT VOLTAGE : VI(
Fig.2 Output current vs. Input voltage
MHz
off
) (V)
Ta= 40°C
V
CE
=10V, IE= −5mA, f=100MHz
500
I
200 100
DC CURRENT GAIN : G
1k
V
O
50
20 10
5
2 1
1002005001m 2m 5m 10m 20m 50m 100m
Fig.3 DC current gain vs. Output current
(OFF characteristics)
=5V
Ta=25°C
OUTPUT CURRENT : I
Data Sheet DTC144WE / DTC144WUA / DTC144WKA
Ta=100°C
Ta= 40°C
O
(A)
www.rohm.com
2/2
c
2009 ROHM Co., Ltd. All rights reserved.
2009.06 - Rev.C
Notes
No copying or reproduction of this document, in part or in whole, is permitted without the consent of ROHM Co.,Ltd.
The content specied herein is subject to change for improvement without notice.
The content specied herein is for the purpose of introducing ROHM's products (hereinafter "Products"). If you wish to use any such Product, please be sure to refer to the specications, which can be obtained from ROHM upon request.
Examples of application circuits, circuit constants and any other information contained herein illustrate the standard usage and operations of the Products. The peripheral conditions must be taken into account when designing circuits for mass production.
Great care was taken in ensuring the accuracy of the information specied in this document. However, should you incur any damage arising from any inaccuracy or misprint of such information, ROHM shall bear no responsibility for such damage.
The technical information specied herein is intended only to show the typical functions of and examples of application circuits for the Products. ROHM does not grant you, explicitly or implicitly, any license to use or exercise intellectual property or other rights held by ROHM and other par ties. ROHM shall bear no responsibility whatsoever for any dispute arising from the use of such technical information.
Notice
The Products specied in this document are intended to be used with general-use electronic equipment or devices (such as audio visual equipment, ofce-automation equipment, commu­nication devices, electronic appliances and amusement devices).
The Products specied in this document are not designed to be radiation tolerant.
While ROHM always makes efforts to enhance the quality and reliability of its Products, a Product may fail or malfunction for a variety of reasons.
Please be sure to implement in your equipment using the Products safety measures to guard against the possibility of physical injury, re or any other damage caused in the event of the failure of any Product, such as derating, redundancy, re control and fail-safe designs. ROHM shall bear no responsibility whatsoever for your use of any Product outside of the prescribed scope or not in accordance with the instruction manual.
The Products are not designed or manufactured to be used with any equipment, device or system which requires an extremely high level of reliability the failure or malfunction of which may result in a direct threat to human life or create a risk of human injury (such as a medical instrument, transportation equipment, aerospace machinery, nuclear-reactor controller, fuel-controller or other safety device). ROHM shall bear no responsibility in any way for use of any of the Products for the above special purposes. If a Product is intended to be used for any such special purpose, please contact a ROHM sales representative before purchasing.
If you intend to export or ship overseas any Product or technology specied herein that may be controlled under the Foreign Exchange and the Foreign Trade Law, you will be required to obtain a license or permit under the Law.
www.rohm.com © 2009 ROHM Co., Ltd. All rights reserved.
Thank you for your accessing to ROHM product informations. More detail product informations and catalogs are available, please contact us.
ROHM Customer Support System
http://www.rohm.com/contact/
R0039
A
Loading...