Audio ICs
Low-current audio headphone driver
BA3575FS
The BA3575FS is a headphone driver with an AVC circuit that keeps the output below a fixed level. It features low current
consumption, and low output noise, and is ideal for use in portable digital audio equipment.
Applications
Portable CD players
Features
1) Low current consumption (when V
quiescent current is 4.9mA).
2) Suitable for use in digital audio equipment (voltage
gain: G
–102dBm typ.).
3) ATT circuit (gain switch).
4) AVC (Auto V olume Control) circuit, for output limiting.
V = 11.8dB, output noise voltage: VNO =
CC = 2.4 V, the
5) Internal standby switch.
6) Internal mute switch.
7) Internal ripple filter.
8) No output coupling capacitor required.
9) Internal beep circuit.
10) SSOP-A20 package.
Absolute maximum ratings (Ta = 25C)
Recommended operating conditions (Ta = 25C)
871
Audio ICs BA3575FS
Block diagram
872
Audio ICs BA3575FS
Pin descriptions
873
Audio ICs BA3575FS
874
Audio ICs BA3575FS
875
Audio ICs BA3575FS
876
Audio ICs BA3575FS
Electrical characteristics(unless otherwis noted, Ta = 25C, VCC = 2.4V, RL = 16Ω, f = 1kHz, DIN AUDIO,
PWSW = ON, MUTE = OFF, ATT = OFF, and AVC = OFF)
877
Audio ICs BA3575FS
Measurement circuit
878
Audio ICs BA3575FS
Measurement circuit switch table (Fig.1)
879
Audio ICs BA3575FS
Application example
880
Audio ICs BA3575FS
Application notes
(1) “Pop” sound
By operating the BA3575FS according to the timing chart shown in Fig.3, it is possible to suppress generation of “pop”
noise in the headphone output.
(2) Application circuits
Provided the recommended circuit constants are used,
the application circuits should function correctly. However, we recommend that you confirm the characteristics of
the circuits in actual use. If you change the circuit
constants, check both the static and transient characteristics of the circuit, and allow sufficient margin to accommodate variations between both ICs and external components.
In particular, the capacitors connected to the OUT 1,
OUT 2, and V
frequency, and have sufficient margin in their temperature characteristics.
Also, use an electrolytic or tantalum capacitor for the capacitor connected to the BIASOUT terminal.
REF pins must have low impedance at high
(3) The PCB pattern for the external components
should be designed carefully to prevent oscillation and
degradation of the circuit characteristics. Keep the wiring
tracks as short as possible, and ensure that there is no
impedance between the common connections.
The ripple filter pins (1 and 2) and the bias amplifier pins
(3 and 4) cannot be used for external power supplies or
reference voltages.
881
Audio ICs BA3575FS
(4) Recommended operating conditions
The curves in Fig.4 below show the maximum allowable
power output (P
CC) for different values of ambient temperature
age (V
(T a). When V
low the dotted line, and do not exceed it.
If the maximum allowable power output for each channel
O (Max.)/ ch) is exceeded, the internal power consump-
(P
tion will exceed the power dissipation capacity of the
package, and destroy the IC.
O (Max.)/ch) plotted against the supply volt-
CC 3.6 V, operate the IC in the region be-
Electrical characteristics curves
882
Audio ICs BA3575FS
External dimensions (Units: mm)
883
Loading...