Rohde & Schwarz Hameg Instruments active PROBE HZO30 User Manual

a c

t i v e P R O B E

H Z O 3 0

Manual

lish

Eng

Pr o be HZ O3 0

ACTIVE PROBE HZO30

All data valid at 23 °C after 30 minute warm-up

Electrical specications

Attenuation ratio: 10:1 ± 0.5 % at DC
Dynamic Measuring
Range: ±8 V
System bandwidth

1)

: 600 MHz (-3 dB)
Bandwidth (probe only): 1 GHz
Maximum rated

input voltage: 20 V

Max. Input Voltage and
Dynamic Measuring Range

The HZO30 Aktiv-Tastkopf active probe is pro­tected against electro-static-discharge voltage
(ESD). Applying input-voltages outside the speci-

ed limits can result in destruction of the probe´s
amplier.

Make sure you comply with the below input
voltage vs. frequency chart to avoid input
linearity errors and damage to the probe.

Input Voltage vs. Freq uency

100

Maximum Input Vol tage

10

Dynamic Measuring Range

Voltage [V] AC pk

1

1M 10M 100M 1G 10G

Frequency [Hz]

Electrical characteristics

Input resistance (System):

>

1 MΩ

Input capacitance (System): 0.9 pF (typical)
Oscilloscope Input Coupling: 50Ω AC / DC
Overshoot: 6% (typical)

Input Impedance

Note that the input impedance of the probe
decreases as the frequency of the applied
signal increases.

Typical input i mpedance

10M

1M

100k

I Z I [Ohm]

10k

100 1k 10k 100k 1M 10M 100M 1 G

Frequency [Hz]

Mechanical characteristic s

Weight (probe only): 96 g
Cable length: 1.3 m

Environmental specications

Altitude

operating: up to 2000 m
non-operating: up to 15000 m

Temperature range

operating: 0° C to +50° C
non-operating: -40° C to +70° C

Maximum relative humidity

operating: 80 %

for temperatures up to +30° C
decreasing linearly to 40 % at 50 °C

1) Connected to oscilloscope > 500 MHz

Subject to change without notice