Introduction
Thank you for investing in the NT3 studio
condenser microphone.
Styli sh and mode rn, the NT3 i s a studio a nd locati on
workhorse. With both P48 phantom power and
internal 9V battery operation, this
microphone is at home anywhere.
Intended for studio, stage and location work, this
versatile handheld or stand mounted microphone
incorporates a true externally polarized condenser
(hyper-cardioid polar response) transducer with an
internal c a ps ule s ho c k mou nt ing s y s tem, an d an u lt ra low noise electronic circuit that has a high immunity to
R.F. interference.
Please take the time to visit www.rodemic.com and
register your microphone for a full ten year warranty.
While there you can view studio tips and techniques, as
well as browse the comprehensive range of accessories
for the NT3 and other
microphones.
condenser
Peter F reedm an
Microphones
Sydney, Australia
- 2 -
Specifi cations
Acoustic
Principle:
Active
Electronics:
Directional
Pattern:
Frequency
Range:
Output
Impedence:
Sensitivity: -39dB re 1V/Pa @ 1 kHz
Equivalent Noise: <16dBA SPL
Maximum
Output:
Dynamic R an ge: >123dB (per IEC651)
Externally polarised 19mm (¾”)
condenser
JFET impedance converter
with bipolar output buffer
Cardioid
(see graph)
20Hz ~ 20, 000Hz
(see graph)
200Ω
(12m V/Pa @ 94dB SPL)
±2dB @ 1kHz
(per IE C651)
+9.5dBu
(@ 1kHz, 1 % THD into 1kΩ)
Maximum SPL: >140dB
(@ 1kHz, 1 % THD into 1kΩ)
Signal/Noise: >77dB SPL
(@ 1kHz, rel 1P a per IEC651)
Power
Requirement:
Output
Connection:
Net Weight: 371 g
Dimensions:
8mA @ P48 (20-60v)
7mA @ P24 (12-30v)
1.4mA @ P12 ( 11-26v)
1.2mA @ 9V (battery)
3-pin XLR
270 x 130 x 50mm
- 3 -
Specifi cations
Frequency Response
ÊÓä
棊
Êä
Ê £ä
`ÊÀiÊ£Ê6É*>
Ê Óä
Ê Îä
ÊÓäâÊ £ääÊ £äääÊ £дКдддК УдКддд
Polar Response
³x°ä
ä°ä
Ó°ä
{°ä
È°ä
n°ä
£ä°ä
£Ó°ä
£{°ä
£È°ä
£n°ä
Óä°ä
ÓÓ°ä
Ó{°ä
Óx°ä
ä ÓÇ
`ÊÀi°Ê£6É*>
ÀiµÕiVÞ\
Ê xääÊâ\
£äääÊâ\
{äääÊâ\
äÂ
Ó°ä
Ê£ä°äÊÊ
Óä°ä
£näÂ
Accessories
Stand mount
with 3/8” - 5/8” thread adaptor
Wind shield
Zip pouch
- 4 -