Rockwell Automation Not Specified MV SMC Flex OEM Components User Manual

MV SMC Flex OEM Components
SMC Flex™ Control Module
Instruction Sheet

Handling Carefully unpack the item and inspect it for damage that may have

occurred during shipping. Immediately report any damage to the
claims office of the carrier. Rockwell Automation will render
reasonable assistance in resolving a damage claim.

A T T E N T I O NA T T E N T I O N

1) Use a grounding wrist strap to minimize the build up of static

charge on personnel.

2) Handle the module by the edges and avoid touching components

SMC-Flex

SMC-Flex

Control Module

Control Module

These precautions are the minimum requirements for guarding

or printed circuit paths.

3) Store devices with sensitive components in the conductive

packaging that the module is shipped in.

against ESD. For more information, refer to Guarding Against
Electrostatic Damage – Publication 8000-4.5.2.

Electrical components may be damaged or
destroyed by electrostatic charges that build up in
personnel during normal activities. To avoid
damage to the equipment, observe the following
precautions.

Identification

Verify the catalog number of the SMC-Flex Control Module.

Table 1 – SMC Flex Control Module Options and Catalog Numbers

Control Module Options Catalog Number

Standard Control 1503E-S1FX

Pump Control 1503E-B1FX

Storage If the voltage sensing board will not be installed immediately after

receipt, store it in a clean, dry and dust-free environment. Humidity
should not exceed 95%, non-condensing.

2 SMC-Flex Control Module – Instruction Sheet

Storage

If the SMC-Flex Control Module will not be installed immediately

after receipt, store it in a clean, dry and dust-free environment.
Humidity should not exceed 95%, non-condensing.

Installation

Refer to MV SMC-Flex Controller – Bulletin 1503E, 1560E and

Refer to MV SMC-Flex OEM Components – Bulletins 1503E,

Installation Instructions (Publication 1503E-IN001A-EN-P) for
complete installation instructions of the SMC-Flex Control Module.

1562E, User Manual (Publication 1560E-UM051A-EN-P) for
complete programming and operating instructions for the SMC-Flex
Control Module.

Additional Publications

Order additional copies of instruction manuals for all Allen-Bradley

medium voltage products from DOX Literature Fulfillment at
www.rockwellautomationdox.com

Medium Voltage Products, 135 Dundas Street, Cambridge, ON, N1R 5X1 Canada, Tel: [phone], Fax: [phone], www.ab.com/mvb

Publication 1503E-IN007A-EN-P – September 2005

Copyright © 2005 Rockwell Automation, Inc. All rights reserved. Printed in Canada.