Rockwell Automation MV SMC Flex OEM Components User Manual

MV SMC Flex OEM Components
Interface Board – Instruction Sheet

Handling

A T T E N T I O NA T T E N T I O N

Carefully unpack the item and inspect it for damage that may have

occurred during shipping. Immediately report any damage to the
claims office of the carrier. Rockwell Automation will render
reasonable assistance in resolving a damage claim.

Do not touch or bend the connectors on the
Interface Board when handling it. Damage to the
connectors may result in loss of communication
signals from the MV SMC Flex to other
components.

A T T E N T I O NA T T E N T I O N

Interface BoardInterface Board

To guard against electrostatic damage (ESD) to equipment the
following precautions should be observed when handling
electrostatic sensitive devices.

1) Use a grounding wrist strap to minimize the build up of static
charge on personnel.

2) Handle the module by the edges and avoid touching
components or printed circuit paths.

3) Store devices with sensitive components in the conductive
packaging that the module is shipped in.

These precautions are the minimum requirements for guarding
against ESD. For more information refer to Guarding Against
Electrostatic Damage - Publication 8000-4.5.2.

Electrical components may be damaged or
destroyed by electrostatic charges that build up in
personnel during normal activities. To avoid
damage to the equipment, observe the following
precautions.

2 Interface Board – Instruction Sheet

Identification Verify the catalog number of the interface board.

Table 1 – Interface Board Catalog Number

System Voltage

800V to 6900V

Note: The following items are supplied with the Interface Board:

• Connectors 80174-014-01 and 80174-014-02

• Ribbon cable assembly 80026-146-53

• Interface cables (6-pin) 80174-201-01 (Qty 2), and (8-pin) 80174-201-02 (Qty 3)

• Mounting bracket, stand-offs and screws

Control Circuit Voltage

and Frequency

110/120 to 220/240 VAC

50/60 Hz

Catalog Number

1503E-INTB

Storage If the interface board will not be installed immediately after receipt,

store it in a clean, dry and dust-free environment. Humidity should
not exceed 95%, non-condensing.

Installation Refer to MV SMC Flex OEM Components – Bulletin 1503E,

Installation Instructions (Publication 1503E-IN001_-EN-P) for

complete installation instructions of the Interface Board.

Additional Publications To order additional copies of Instruction Manuals for all Rockwell

Automation medium voltage products, please contact a Rockwell
Automation sales office or your local distributor.

Medium Voltage Products, 135 Dundas Street, Cambridge, ON, N1R 5X1 Canada, Tel: [phone], Fax: [phone], www.ab.com/mvb

Publication 1503E-IN002C-EN-E – May 2008 Copyright © 2008 Rockwell Automation, Inc. All rights reserved. Printed in Canada.

Supersedes Publication 1503E-IN00 2B-EN-P – January 2006