Rockwell Automation 1485A User Manual

Installation Instructions

Preliminary

Subject to Change

September 3, 2008

Bulletin 1485A KwikLinkt Lite, Manual crimp tool

IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.

Refer to the product catalog pages for additional information.

Safety Precautions

S The product does not provide a safety cover or any other

safety devices. Use the product with sufficient care so that you do not pinch your fingers in the crimp section or between the handles.

S Do not disassemble or modify the product.

S Do not use the product for any purpose other than its

intended purpose or applications specified in the user manuals.

S Do not drop the product or subject it to abnormal vibration

or shock. These may result in malfunction.

S The product is a manual tool. Do not attach it to any

machine or device that is not manually operated. Doing so may result in malfunction or damage.

S Use the product with care and be careful not to drop it on

your foot.

Precautions for Correct Use

S Do not install the crimp tool in the following locations.

S Locations subject to corrosive gas or inflammable gas S Locations subject to excessive dust and dirt S Locations subject to oils, acids, or other chemicals S Locations directly subject to vibration or shock

S The crimp tool is set to a suitable bottom dead point

(crimping height) before shipping from the factory. Discontinue use of the crimp tool immediately if it becomes loose or otherwise misaligned.

S After using the crimp tool, wipe off any dirt or foreign matter

and store it in a dry location.

S Never use paint thinner or other organic solvents to clean

the crimp tool. These may damage the crimp tool.

Simple Manual Crimp Tool

Part Names

1485A--KCrimp

Spring

Crimp block

Base block

Lever

Crimp Operation

1. Set the center of the connector cover (see arrows) in the center of the crimp block of the Crimp Tool.

1485P--K1TG4 1485P--K1DL4

2. Crimp the connector until you hear the connector lock into place.

Note:

S Do not crimp the edge of the connector cover. S Do not crimp at the back of the crimp block. S Be sure to set the Connector in the correct orientation.

Handle

1485P--K1DL4—Drop Line Connector

Preliminary

Subject to Change

September 3, 2008

1485P--K1TG4—Trunk Line Connector

Basic Specifications

Catalog number 1484A--KCRIMP

Bottom dead point clearance 8.2 mm (0.32 in.)

Weight Approx. 350 g (12.35 oz)

Dimensions (W×H×D) 167 × 130 × 24 mm (6.57 x 5.12 x 0.94 in.)

Dimensions

Closed

Open

3. After completing the crimping operation, check the cable to be sure is has been crimped properly.

1485P--K1DL4—Drop Line Connector

There must be no gaps here.

1485P--K1TG4—Trunk Line Connector

Connector must be locked on the left and right.

There must be no gaps here.

10000029236Ver 00

PrintedinUSA