Rocktron BASS15 User Manual

Instruction Manual

Your Rocktron Bass15 Bass Amplifier has been tested and complies with the following Standards
and Directives as set forth by the European Union:

Standard(s): IEC60065 Professional Audio/Video or Similar
Equipment, EN55013:1997, EN61000-3-2 (1995)
EN61000-3-3(1995), EN55020:1995, CSA E65-94

This means that this product has been designed to meet stringent guidelines on how much RF
energy it can emit, and that it should be immune from other sources of interference when properly
used. Improper use of this equipment could result in increased RF emissions, which may or may
not interfere with other electronic products.

To insure against this possibility, always use good shielded cables for all audio input connections.
This will help insure compliance with the Directive(s).

Specifications

OUTPUT

SPEAKER

WEIGHT

BOX DIMENSIONS

INPUT IMPEDANCE

HEADPHONE IMPEDANCE

CD/MP3 INPUT

Copyright © 2008 GHS Corporation
All Rights Reserved.

15 Watts
Custom 8” Speaker 8 Ohms

16.15bs., 7.35KGs

13.75” x 11” x 14.5”
348mm x 276mm x 365mm
1M Ohm
32 Ohms or greater (600 Ohms for best results)
Yes

Precautions

NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO
PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL
HANDLING.

• All warnings on this equipment and in the operating instructions
should be adhered to and all operating instructions should be followed.

• Do not use this equipment near water. Care should be taken so that
objects do not fall and liquids are not spilled into the unit through any
openings.

• The power cord should be unplugged from the outlet when left unused
for a long period of time.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT
SHOULD BE SERVICED BY QUALIFIED PERSONNEL ONLY. DO NOT
MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS
EQUIPMENT AT ANY TIME. DO NOT TAMPER WITH INTERNAL
ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT, AS
WELL AS CAUSING SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat. This unit is designed to operate between
32° F and 104° F (0° C and 40° C). This unit may not function properly under
extreme temperatures.