Rocktrail BG 2010 User Manual

0123 / 13

Components of the camping stove BG 2010

The device consists of 1 upper part of the camping stove (also upper
part), 2 butane cartridges of 190 g (No. 52150), 1 lower part of the
camping stove  cartridge holder (also lower part), and 1 set of Instructions
for Use. Please check the completeness of the article.

Intended use

Camping Stove with Gas Cartridge BG 2010 is intended for private use
(e.g. cooking tee, warming up tinned food, etc.) and can be operated
only outside.

Important:

Please read these instructions for use carefully before you attach the
gas cartridge to get acquainted with the device first. Keep the leaflet for
further reference.

It is not allowed to change settings or make modifications from those
set by the manufacturer. It could be dangerous to change the structure
of the device on your own authority, to remove parts or to use parts
which are not approved by the manufacturer.

Use solely butane gas cartridges of the type 200, picture 1, according
to EN 417 (190 g), which are commercially available, which are
recommended for this device and which correspond with the European
Norm EN 417 (as e.g. butane cartridges provided  CFH No. 52150).
Butane gas cartridges of 190 g you use must have an inscription EN

417. These standard gas cartridges are available in building stores. This
device may be only used with a pressure gas cartridge (cartridge with
a piercing point connection  CFH No. 52150). It could be dangerous
to connect other gas receptacles.

Never fit a gas receptacle (butane cartridge of 190 g) before reading the
instructions on it.

Use only outside.

Security instructions and warnings

· Do not unscrew the lower part of the cartridge holder, until the butane
cartridge is completely empty (shake it a little if splashing of liquid is
audible). Otherwise there is imminent danger of gas escaping which
could ignate next to a heat source and thus cause a really dangerous
situation (danger of explosion).

· Make sure before attaching the gas cartridge that the gasket (between
the device and the gas cartridge) is not missing and is in good condition
(see drawing above  picture 5). The rubber gasket is easily visible

Instructions for Use

No. 48830 Camping Stove BG 2010

IE

IAN 85830

EN CY

picture 1 picture 2 picture 3 picture 4

gas regulation

valve

picture 5 safety latch

black

rubber gasket

if you hold the upper part of the camping stove as shown on picture

5. It is necessary that there is a black rubber gasket inside on the
piercing pin and that it is in a good condition. If this gasket is missing
do not use the device (danger of leakage).

· Do not use any device with damaged or worn out gasket. Do not use
any device which is leaking or damaged or which does not work
properly.

· Only fit the gas cartridge when outside, where there are no flammable
materials or combustible sources in the neighbourhood, no electric
stoves or open fire, and in a sufficient distance from other persons.
Do not smoke when fitting the cartridge.

· Do not change the butane cartridges if you are not absolutely sure
that the cartridges are completely empty. Follow safety instructions
stated on the butane cartridge.

· Keep the device away from children. Children are not allowed to use
the device (danger of injury).

· Do not shake the device immediately before starting up, in order that
the liquid gas cannot flow to the burner and cause problems with
lighting.

· Use the camping stove only on a horizontal level.

· Only change the cartridge when outside, far away from possible

combustible sources, as e.g. open fire, pilot flames, electrical hot
plates and similar, and away from other persons and animals. Before
changing the butane cartridge always close the gas regulation valve.

· Used butane gas cartridges are one-way receptacles. Refilling is not
permitted and could be very dangerous.

· Protect the butane cartridge and the device from direct exposure to
sun light (impact of heat). Do not expose it to temperatures over 50°C.

· Do not use in closed rooms. Make sure the device is used only
outside  do not use it in shafts or below ground level, because the

gas here is heavier than air and it can spread without control.

· The device must always be positioned on a stable and horizontal
basis.

· Do not use it in a tent - danger of suffocation due to a quick consumption
of oxygen or danger of fire.

· Use the device only at a safe distance from inflammable materials (at
least 500 mm from the walls and 1500 mm from the ceiling). Make
sure that the rising heat and vapours do not endanger the ceiling.
Prevent accumulation of heat, eventually increase the safe distance
to the ceiling.

· The device can reach very high temperatures at the burner during
normal operation.

· Do not leave the device unattended if it is on. Protect the butane
cartridge from becoming warm or hot. Prevent accumulation of heat.

· ATTENTION: Accessible parts of the device can be very hot. Keep
small children away from the device (danger of injury). Never touch
the burner if it is still hot. When the device is not in use, protect it from
dust and humidity. Never keep the device below ground level.

· If the flame is blown out due to a wind blast, immediatelly close the
gas regulation valve, so that no more gas can flow uncontrolled out
of the device.

· Do not use the device close to inflammable or heat sensitive materials

(danger of fire).

· Do not make any modifications to the device. Malfunctions can be
only fixed by an authorized specialist dealer or by the manufacturer.
Repairs can be done only by an authorized specialist dealer or by
the manufacturer.

· If gas leaks out of your device (you can smell gas) take it immediately
outside to a place with a good air circulation and without any combustible
sources, where you can search for the leaking spot and fix it. Only
test gas tightness of your device when outside. Never search for
untight connections using a flame, use always soapsuds.

· Use only cooking pots with a maximum diameter of 20 cm and a
maximum height of 12 cm. When using bigger cooking pots, heat
could accumulate and the stove could get damaged. When cooking
ensure there is a safe distance between the pot rim and the level
inside, so that the cooking water cannot spurt out.

· Use the stove only on a stable and even base.

Test for leaks

Only test gas tightness when outside by spreading soapsuds over the
connections at the outer side of the device, where the gas flows, or spray
these connections with a leak-seeking-spray. Never search for untight
connections using a flame, use always either soapsuds or a leak-seeking­spray! Do not put a device into operation with damaged or worn out
gaskets. Never use a device where gas is leaking, which is damaged
or does not work properly.

Setting the size of the flame

It is possible to regulate the size of the flame by turning the black gas
regulation valve (see picture 4 / (+) = open gas supply, (-) = shut gas
supply). By turning the gas regulation valve in direction (+) the gas supply
is opened. By turning further in direction (+) the gas flow reaches its full

Löt- und Gasgeräte GmbH
Bahnhofstraße 50, D-74254 Offenau
Tel. [phone]
Fax [phone]
Internet: www.cfh-gmbh.de
E-Mail: [e-mail]

Stand: VO-12.12

performance (big flame). By turning the gas regulation valve in direction
(-) the gas flow decreases (small flame).

Steps to be taken before attaching the butane gas cartridge

Only change cartridge when outside and far away from other persons.
After each attachment or a change of a cartridge you must carry out a
test for leaks (see Test for Leaks). Make sure that all attachments and
other connections are correctly connected and nothing is damaged.
Ensure that parts where the gas flows are not damaged. Never use a
damaged device. Before attaching the butane cartridge, close the gas
regulation valve on the device (see picture 4 / (-) switch off gas supply).
Before attaching each new gas receptacle check the gasket (visual check
 picture 5). It is necessary to ensure that at the upper part of the

stove inside on the piercing pin there is a black rubber gasket, and
that this gasket is in a good condition (see drawing - picture 5). If
this gasket is missing or is damaged do not use the device. The
replacement gasket can be changed only by an authorized specialist
dealer or the manufacturer. Do not make any alterations to the
device! Make sure, always before you light the flame on the burner that

all parts are gastightly connected.

Attaching the butane cartridge

When assemblying the device hold it upright (burner pointing upwards
and the bottom of the lower part of the camping stove  cartridge holder

- pointing downwards). Screw all parts together precisely and without
interruption. Do not strip the screw thread.
Close the regulation valve on the upper part of the device by turning it
clockwise (-) (see drawing - picture 4). Place the butane gas cartridge
into the cartridge holder (see drawing - picture 2). Now screw the cartridge
holder gastightly to the upper part (see picture 3), till the latch at the side
snaps (see picture 5).

Changing the butane cartridge

It is possible to change the butane cartridge only if it is completely empty
(see section headed Security instructions  Warning). Check that the
cartridge is empty before changing (shake it a little if splashing of liquid
is audible). Make sure the flame on the burner is extinguished before
loosening the cartridge. You can loosen the lower part from the upper
part by pressing the security latch at the side (see picture 5) and rotating
the lower part counterclockwise (picture 1). Take the empty butane
cartridge from the lower part of the device and dispose of it accordingly.
Now you can attach a new butane cartridge (see Steps by attaching the
butane cartridge).

How to operate the device

After properly fitting of the butane cartridge and testing for leaks (to be
carried out outside), turn now the gas regulation valve by about a half
rotation counterclockwise towards (+). Light the flame on the burner tip
with a match or a lighter and only now turn on completely the gas
regulation valve, so that the flame can reach its highest performance.
Do not shake the device immediately before lighting the burner and after
having lit it do not move it any more. Otherwise there is a danger that
the liquid gas will leak and an uncontrolled flame will ignite. Place the
device on an even surface protected from wind. Wind could extinguish
the flame and the gas could further escape from the device  danger
of injury or burn. In a case the flame extinguishes uncontrolled (e.g.
wind blast) immediately turn off the gas regulation valve (see picture 4
/ (-) = switch off gas supply) and restart the device again as described
above. Use the device only in an upright position and under a permanent
supervision of adult persons.

Switching off the device

By turning the gas regulation valve clockwise to the right (-) (see picture

4) the supply of gas is stopped and the flame extinguishes. Have in mind
that the burner is still very hot and that it must cool down before it is
stored.

Storage and transport

Follow the safety instrauctions stated on the butane cartridge.
Storage: Store the device in a vertical position!. Never store the device
or the butane cartridges below ground level (e.g. cellar, boiler room).
Storing area must be sufficiently ventilated.
Transport: Ensure that the device stands securely upright and it must
not fall over or fall down. Always secure the device during the transport.

Care of the device + Repair service

It is allowed to use only recommended spare parts. Do not use a device
where any parts are damaged. Any repairs as well as replacement of
the nozzle can be carried out only by an authorized specialist dealer for
liquid gas or by the manufacturer. In case of a repair contact the
manufacturer at the maintenance address below. The nozzle is marked
with 22 (nozzle No. 22  corresponds with the nozzle diameter of 0,22
mm). Do not make any modifications to the device.

Changing the gasket

When changing the gasket the wider lower rim of the new gasket must

fit precisely to the gasket holder on the piercing pin. The rubber gasket
can be replaced only by an authorized specialist dealer or by the
manufacturer.

Warranty

The warranty for this device is 3 years from the date of purchase. The
warranty starts with the date of purchase. Please keep the original receipt
in a safe place. This document is required as a proof of purchase. If any
material or manufacturing defects occur within 3 years from the date of
purchase of this product, the product will be either repaired or replaced
free of charge for you - at our discretion. This guarantee presumes that
you submit the defective device and the proof of purchase (receipt)
together with a short description of the defect and when the defect
occurred within 3 years. In case that the defect is covered by our warranty,
you will receive either the repaired product or a new one. In case of a
warranty claim, please contact us by E-Mail under [e-mail].
We will contact you immediately.

Cleaning the device

It is possible to clean the device with a dry cloth only when the burner
has cooled down. Do not use any cleansing agents because the openings
in the burner and the nozzle could become blocked.

Environmental instructions

The gas used is environment-friendly liquid gas, which does not burden
or damage the environment and it is not dangerous for the ozone layer.
The butane cartridge or its contents do not have a restricted shelf-life.
Follow the regulations for the liquid gas.

Disposal of the butane cartridge

Totally emptied butane cartridges must be disposed of by using the
Dual recycling system. Butane cartridges, which are not completely
empty have to be disposed of at collection centres for harmful substances.

Disposal of the device

The device is produced of recyclable materials. To dispose of or to
recycle this device, get in touch with an authorized local Recycling Office
or a waste disposal company.

Technical data

Gas type: butane, unregulated, in a pressure gas

cartridge

Related heat input: appx. 70 g/h

appx. 0,97 kW
Nozzle No. 22
Nozzle: Ø 0,22 mm
Device category: vapor pressure butane (I3)
Burning time with 1 butane cartridge approximately 2,5

hours

The performance in the operating manual applies to measurement results
with test gas under test conditions. When using the provided butane
cartridge under normal conditions, deviations in the related heat input
can occur. (Important information: The ambient temperature has an

essential influence on the performance of the device. As a general
rule is that the performance decreases at low temperatures).

We wish you much pleasure with your Camping Stove.

Technical and optical parameters subject to change

Status: 12/2012

Maintenance address and manufacturer: