Rockford Fosgate CPU0204 Operations & Parts List

CPU0204 1

Operations & Parts List CPU0204

Electric Pressure Washer

NOTE: REFER TO PRODUCT MANUAL FOR
ALL SAFETY INSTRUCTIONS

Table Of Contents

 Technical Data
 Important Safety Tips, Precautions, Warnings and Usage

Instructions

 Assembly Instructions
 Operating Instructions
 Detergents
 Clean-up and Storage
 Cleaning Tips
 Troubleshooting Tips
 Explosive Drawing
 Parts List

Technical Data

Mains voltage:…………………………….…... 120 V
Mains frequency:……………………………… 60 Hz
Max. operating pressure:………………………1400PSI
Water consumption:…………………………... 1.4 GPM

Max. pressure water supply:………………..... 0.3 Mpa

Max. water temperature:………………………. 5-60°C
Weight:…………………………………………... 9 Kg

Important Safety Tips

Never point the high-pressure nozzle at people or animals.
Never drink alcohol or use drugs while operating the pressure

washer.

Never operate the pressure washer while standing in water.
Never touch the electrical plug with wet hands.

Never let electrical connections rest in water.

Never operate pressure washer without the water turned on.
Never use hot water with this pressure washer.

GROUND FAULT CIRCUIT INTERRUPTER
(GFCI)

This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply
cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord
become necessary, use only identical replacement parts that include GFCI protection.
This unit is equipped with a Ground Fault Circuit Interrupter (GFCI). When connecting the GFCI to the receptacle, the
indicator should appear red. If the indicator is not red, depress the RESET button on the GFCI until the indicator
appears red. If the indicator does not appear red, please see Section titled "Troubleshooting" for more information.

IMPORTANT SAFETY PRECAUTIONS

WARNING: When using this product, basic precautions should always be followed, including the following:

1. Read all instructions before using the product. Save all safety instructions.

2. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs.

3. Risk of injection or injury - do not direct the high pressure water stream at any people or animals.

4. Do not allow children to operate the pressure washer at any time.

5. To reduce the risk of injury, close supervision is necessary when the pressure washer is used near children.

CPU0204 2

6. Know how to stop the unit and reduce pressure immediately. Be completely familiar with the controls.

7. Stay alert - always be aware of where you are directing the high pressure spray

8. Keep cleaning area clear of all people.

9. Keep good footing and balance at all times - do not overreach or stand on an unstable support.

10. The work area should have adequate drainage to reduce the possibility of a fall due to slippery surfaces.

11. Follow the maintenance instructions specified in the manual.

12. To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands.

GENERAL SAFETY PRECAUTIONS

1. Intended for outdoor household use only.

2. High-pressure hose can develop leaks from wear, abuse, kinking etc. Do not use a damaged hose.

3. Do not use the pressure washer in areas near combustible materials, combustible fumes, or dust.

4. Some chemicals or detergents may be harmful if inhaled or ingested causing severe injury. Use a respirator or
mask whenever there is a chance that vapors may be inhaled. Read all instructions included with the mask so you are
certain the mask will provide the necessary protection against inhaling harmful vapors.

5. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice
has not formed. Do not store the unit anywhere that the temperature will fall below 0°C (32°F).

6. DO NOT MAKE ANY MODIFICATIONS TO ANY OF THE COMPONENTS! Units with broken or missing parts, or
without the protective housing or covers should NEVER be operated

7. Keep the high-pressure hose connected to the pressure washer and the spray gun while the system is pressurized.
Disconnecting the hose while the unit is pressurized is dangerous, and may cause injury.

8. Do not leave the pressure washer unattended while the power switch is ON.

9. Keep water spray away from electrical wiring or fatal electric shock may result.

SERVICING OF A DOUBLE-INSULATED APPLIANCE

In a double-insulated product, two systems of insulation are provided instead of grounding. No means of grounding is
provided on a double-insulated product, nor should a means for grounding be added to the product. Servicing a
double-insulated product requires extreme care and knowledge of the system, and should be doneonly by qualified
service personnel. Replacement parts for a double-insulated product must be identical to the parts they replace. A
double-insulated product is marked with the words "DOUBLE INSULATION" or "DOUBLE INSULATED". This symbol

may also be marked on the product.

USE OF EXTENSION CORDS

Use of an extension cord with this product is NOT RECOMMENDED. If you must use an extension cord, use only
extension cords that are intended for outdoor use. These cords are identified by a marking "ACCEPTABLE FOR USE
WITH OUTDOOR APPLIANCES, STORE INDOORS WHILE NOT IN USE." Use only extension cords having an
electrical rating not less than the rating of the product. Examine extension cord before use. Do not use damaged
extension cords! Do not pull on cord to disconnect from receptacle, always disconnect by pulling on plug. Keep cord
away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the
product from the extension cord.

WARNING - To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug

with wet hands.

PROPER USE OF THE PRESSURE WASHER

THIS UNIT IS INTENDED FOR USE WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE WASHER.

1. Operate the pressure washer at no more than the fluid pressure rated for the pressure washer. Never run the
pressure washer without a water supply. Running the unit without a water supply will cause irreparable damage to the
unit.

2. Make sure that the water supply you use for the pressure washer is not dirty, sandy, and does not hold any
corrosive chemical products. Using a dirty water supply will compromise the long life of the pressure washer.

3. CAUTION - The pressure washer can be used for a variety of applications including washing cars, boats, patios,
decks, garages etc. where high pressure is necessary to remove dirt and debris.
High-pressure water flow can damage the work surface if not used properly! See the section titled "Operating
Instructions" for more details. Always test the spray in an open area first.

4. NEVER move the unit by pulling on the high pressure hose. Use the handle provided on the top of the unit.

CPU0204 3

5. Always hold the high pressure gun and wand with two hands. Keep one hand on the gun/trigger, while supporting
the wand with the other hand (see diagram).

6. When dispensing detergent, the pressure washer applies detergent to the cleaning area at low pressure only. Once
the detergent has been applied, spray the detergent off of the work area by using the adjustable nozzle.

ASSEMBLY INSTRUCTIONS

Unpacking the Carton

After opening the carton, please remove all parts and check them against the following list of components that are
included:

Fig. 1

1) Inlet connector

2) Power plug with GFCI

3) Main switch

4) Handle

5) Quick connector

6) Detergent bottle

7) Bottle Nozzle

8) Hose connector with appliance

9) Hose connector with spray gun

10) High pressure washer hose

11) Packing of fittings

12) Tip cleaner

13) Instruction manual

14) Trigger safety lock

15) Pistol grip

16) Spray lance

17) Turbo lance

To assemble the enclosed parts, please refer to the steps that follow:

Step 1

Attach the high pressure hose to the gun.
Use a wrench to tighten the fitting.

S

tep 4

Attach the garden hose to the brass
connector which on the front of pressure
washer. Connect the garden hose to the
waterspout.

Step 3

Attach the high-pressure hose to the
male fitting on the back of the pressure
washer.

Step 2

Connect the adjustable lance to the gun.