Robern PL40GBL Installation Manual

General Notes

Robern
701 N. Wilson Ave.
Bristol, PA 19007

800.877.2376

MPFL LIGHT FIXTURE (Dimming)

1. It is important that the armored cable be located
during electrical rough in.

2. When surface mounted, the armored cable should be
routed behind the cabinets through the wall cavity.

3. When recessed mounted, the armored cable is
routed above the master xture then back down to
the remote.

4. The light xtures can be dimmed with the proper
dimmer. The recommended dimmer is the
Lightolier model ZP600EB or MSP600EB .
Be sure to read the information concerning
Dimming “burn-in” in the dimmer operation and
troubleshooting section.

5. If you experience any problems with your light, or
require parts, contact your dealer or Robern
customer service directly between 8 and 5p.m.E.S.T.
Robern, Inc.
701 North Wilson Ave - Bristol, Pa 19007
800-877-2376 – Fax [phone]

Limited Warranty One Year Term

ROBERN warrants to the original purchaser that, it will, at its elec­tion repair, replace, or make appropriate adjustment to products
made by this company shown to have signicant defects in mate­rial or workmanship which are reported to ROBERN in writing
within one (1) year from the date of delivery. ROBERN is not
responsible for installation costs.

The warranty is void in the event the product is damaged in tran­sit, or if damage or failure is caused by abuse, misuse, abnormal
usage, faulty installation, damage in an accident, improper main­tenance, or any repairs other than those authorized by ROBERN.
At the expiration of the one year warranty period, ROBERN shall
be under no further obligation under any warranty, expressed or
implied, including the implied warranty of merchantability.

ROBERN shall not be liable for any consequential damages aris­ing out of or in connection with the use or performance of its
products. Some states do not allow limitations on how long an
implied warranty lasts or do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.

Any liability against ROBERN under any implied warranty, includ­ing the warranty of merchantability, is expressly limited to the
terms of this warranty. Permission to return any merchandise
under this warranty must be authorized by ROBERN and returned
prepaid by the purchaser. Claims under this warranty should be
sent directly to your dealer.

Part List – MPFL Light Fixture

A. (1) MPFL Light Fixture master

B. (1) MPFL Light Fixture remote

C. (2) Bulb Cover

D. (2) 36” Fluorescent Bulb

E. (4) End Cap

F. (1) 72” Armored Cable

G. (4) Connecting Blocks (Supplied w/ Cabinet)

Hardware Bag Containing the Following:

H. (4) Cross Bracket

I. (4) Keyhole Bracket

J. (4) Mounting Bracket

K. (4) #6 Finger Nut

L. (4) Wire Nut

M. (4) #10 x 3/4” Flat Head Screw

N. (4) #10 x 3” Pan Head Screw

O. (16) #10 x 1/2 Pan Head Screw

Do not throw away Carton

until you have checked the

carton and all internal

packing completely for

hardware.

INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS
WITH HOMEOWNER.

MPFL Light Fixture 209-1030
cab•fax #1030

RECORD SERIAL NO. _______________________

1

209-1030 MPFL LIGHT FIXTURE

1. Wiring the MPFL Light Fixture

1. Loosen these screws on
each end of the compartment

2. Remove the
access door to
reach the wiring
inside the

compartment

1. The xture pair is congured as a “Master” and “Remote”. The Master has the wiring compartment while
the Remote does not. See Figure A

2. The wiring compartment of the Master contains supply and ground connections and the xture-to-xture
connections for the supplied armored cable. See Figure B.

3. Wiring of the units before installing the lights is recommended.

4. Wire the light xtures as shown in Figure B.

Fig. A

209-1030 MPFL LIGHT FIXTURE

2

BALLAST

BALLAST BOX

MASTER
FIXTURE

REMOTE
FIXTURE

W B

G

B

B

MTFL/MPFL DIMMING WIRING DIAGRAM

IN THE REMOTE FIXTURE, BE SURE TO CONNECT
EACH YELLOW WIRE TO EACH YELLOW WIRE AND
EACH BLUE WIRE TO EACH BLUE WIRE (A TOTAL OF 4)
TOGETHER USING THE WIRE NUTS SUPPLIED.

3/8 ARMORED CABLE

Y

Y

R

R

15 A
CIRCUIT

THE COLOR OF THIS SWITCH
WIRE CAN VARY ACCORDING
TO MANUFACTURER

MPFL Fixture Wiring Diagram (Dimming)

Fig. B

3

209-1030 MPFL LIGHT FIXTURE