Rigol RPL2316 User guide

RIGOL

User’s Guide

RPL2316

LOGIC PROBE

© 2013 RIGOL Technologies, Inc. All R ights Reserved.

General Safe ty Summary

Connect and disconnect the probe properly.
Connect the adaptor before using.
Observe all terminals ratings.
Do not touch exposed connections and components after power on.
Do not operate with suspected failures.
Do not operate without covers.
Do not operate in an explosive atmosphere.
Do not operate in wet conditions.
Keep product surface clean and dry.
Pay attention to handling safety.

- 1 -

Product Overview

Being a high performance logic probe,
RPL2316 connects the digital buses
and signals under test to the
MSO4000 series digital oscilloscope.
RPL2316 separates 16 digital
channels into two branch headers,
called channel group. Each header
includes 8 signal channels (D0-D7 and D8-D15) plus 12 gr ound channels. All
the channels are marked with different colors and numbers (or letters) on
the probe adaptor label to identify different channels. RPL2316 provides 8
signal leads and 12 ground leads for each header to realize flexible
connection of signals and reference ground and provide better signal
integrity. Note: in any case, make sure that the connection between probe
adapter and the channel group is reliable.

- 2 -

The Using Method of the Logic Probe

1． Connect RPL2316 to the oscilloscope: push the buttons on both

sides of the logic probe single head and connect it (with “RIGOL”
facing upward and the label facing downward) to the digital channel
input terminal [LOGIC D0-D15] at the front panel of the MSO4000
series digital oscilloscope in the arrow direction as shown in the figure
below.

- 3 -