Ricoh nadfax Technical Bulletin

RICOH Technical
Model:
NAD 30S/30/40
Bulletin
Date:
31-May-98
PAGE: 1/6
3
Subject: From: Classification:
This bulletin contains corrections for the Fax Option Type 450 service manual.
Service Manual Corrections
Technical Service Department.
Troubleshooting Mechanical Paper path Other ( )
Part information Electrical Transmit/receive
Prepared by:
Action required Service manual revision Retrofit information
Y. Furuya
Chapter 3
Problem
1) The installation procedure was not suitable for the Taiwan version
2) A bracket must be removed before installing the expansion box; this was not mentioned.
3) The procedure for attaching the PTT approval label was missing.
Correction
1) The installation procedure has been modified for all versions, including Taiwan.
2) Missing steps have been added. (Items 2 and 3 above; refer to pages 2 to 5.)
RICOH Technical
Bulletin
PAGE: 2/6
NOTE:
[A]
To install the fax unit, the Expansion Box Type 450 is required in addition. The following procedure is written on the premise that the expansion box has not been installed.
[C]
[D]
[B]
A693I500.WMF
[I][J]
[I]
[F]
A693I501.WMF
[M]
[F]
[E]
[L]
[K]
[H]
A693I519.WMF
1. Remove the rear cover [A] (4 screws) and the left side cover [B] (4 screws), as shown.
2. Cut away the covers [C] and [D] (shaded parts), as shown.
NOTE:
3. Remove the cover [E] from the expansion box, then install the FCU cover bracket [F] (1 screw) as shown.
NOTE:
4. Remove the bracket [G], and run the cable [H] through the clamps [I], then install a metal core [J] as shown.
NOTE:
5. Connect the harness [K] to CN355 on the expansion box, then install the expansion box (4 screws) so that the CN350 fits in CN304 [L] on the BiCU.
NOTE:
If installing the fax hard disk option at the same time, refer to the hard disk installation procedure before going on to the next step.
The bracket [F] is included in the fax unit.
The metal core [J] is not installed the model for Taiwan.
Use a magnetic screwdriver so as not to drop any screws inside the machine.
A693I503.WMF
6. Attach the modular jacks [M] to the bracket [F] as indicated on the bracket.
RICOH Technical
[N]
[P]
Bulletin
PAGE: 3/6
[Q]
[O]
[U]
[S]
A693I504.WMF
A693I514.WMF
[R]
[O]
[T]
A693I505.WMF
[R]
[V]
A693I515.WMF
7. Set the locking support [N] and the edge saddle [O] as shown, then install the NCU/Speaker assembly [P] (2 screws).
8. Connect the cable [Q] and the harness [R] as shown. The harness [R] must run through the edge saddle [O] as shown.
9. Turn on the battery switch (SW1) on the FCU [S] then set it in the right-most slot of the expansion box as shown. Connect the harness [R] to the FCU (CN328 and CN330), then slide the FCU [S] all the way in (1 connector).
10. Install the brackets [T] (3 screws), [U] (2 screws) and [V] (1 screw) as shown.
NOTE:
The bracket [U] is installed only in the model for Taiwan.
Loading...
+ 6 hidden pages