Ricoh DF64 Technical Bulletin

RICOH Technical

Bulletin

PAGE: 1/2

Model:

Subject:
From:
Classification:

Symptom

When feeding small size originals lengthwise, a original jam may occur in the area on the
exposure glass where the original is to be fed out (position [A]).

Phoenix II /Cattleya/Iris/Lilac (ADF)

ADF Jam

Technical Service Dept., GTS Division

Troubleshooting
Mechanical
Paper path
Other ( )

Part information
Electrical
Transmit/receive

Date:

15-Sep-99

Prepared by:

Action required
Service manual revision
Retrofit information

No.:

H.Matsui

[A]

RA204010

Cause

The rear side of the leading edge of the originals catches ridge [B] (this ridge was created
during the molding process), near one of the ribs of the paper inverter guide plate (P/No.
A5481210).

[B]

RICOH Technical

Bulletin

PAGE: 2/2

Model:

Action in the field

Until the permanent countermeasure is implemented, the ridge [B] should be smoothed
down (remove if possible) with sandpaper.

From the serial numbers in the following table, a permanent countermea sure will be
applied (the mold used to produce the inverter guide plate will be repaired). Therefore, the
above action should not have to be done.

Phoenix II /Cattleya/Iris/Lilac (ADF)

CODE SERIAL NUMBER
A663-15 9A19900001
A663-17 A7519090001
A663-22 AL79090001
A663-26 3N88990001
A663-55 L0419090001
A663-57 A7519890299
A663-62 AL79890001

Date:

15-Sep-99

No.:

RA204010