Ricoh cif-a Technical Bulletin
|
Technical Bulletin |
No. RTB-014 |
|||||
|
|
|
|
|
|
||
SUBJECT: Interface Kit Type A CE Mark Compliance |
|
DATE: December |
|||||
|
|
|
|
|
|
31, |
’95 |
|
|
|
|
|
|
PAGE: 1 of 9 |
|
|
|
|
|
|
|
|
|
PREPARED BY: N. Kaiya |
|
|
|
FROM: 2nd Technical Support Section |
|||
CHECKED BY: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CLASSIFICATION: |
|
|
|
|
MODEL: |
|
|
Action Required |
|
|
Revision of service manual |
Interface Kit Type A |
|||
Troubleshooting |
|
|
Information only |
for DFC - α |
|||
Retrofit Information |
|
|
Other |
|
|
|
|
|
|
|
|
|
|
|
|
To comply with the CE mark standards, the following modifications have been made to the Interface Kit Type A.
<Ferite Core>
Two ferrite cores are packed with the kit. Please refer to the attached installation procedure of the interface kit for where to use these ferrite cores.
<Main Board ROMs>
The mainboard ROMs packed with the interface kit have been standardized with the main board ROM on the copier main board.
A3996782 --> A1095104
A3996783 --> A1095106
At the same time, the ROMs have been updated from suffix L to suffix M.
A1095104L --> A1095104M
A1095106L --> A1095106M
The purpose of this update is to cut the signal from the scanner unit to the IPU when using the copier in scanner mode. This will reduce the amount of electromagnetic emission from the copier.
<CE Mark>
The CE mark is printed on the carton box. Please check this CE mark to distinguish new kits from old kits, since there is no serial number for this kit.
Technical Bulletin |
No. RTB-014 |
||
|
|
|
|
SUBJECT: Interface Kit Type A CE Mark Compliance |
|
DATE: December |
|
|
|
31, |
’95 |
|
|
PAGE: 2 of 9 |
|
|
|
|
|
|
|
|
|
|
|
|
|
Technical Bulletin |
No. RTB-014 |
||
|
|
|
|
SUBJECT: Interface Kit Type A CE Mark Compliance |
|
DATE: December |
|
|
|
31, |
’95 |
|
|
PAGE: 3 of 9 |
|
|
|
|
|
|
|
|
|
|
|
|
|
Loading...