Ricoh adc1scn Technical Bulletin
!"#$% T
echnical Bulletin
PAGE: 1/1
Model:
Subject:
From:
Adonis-C1 (Scanner Option)
Service Manual Correction
Technical Services Dept., GTS Division
Classification:
Troubleshooting
Mechanical
Paper path
Other ( )
Part information
Electrical
Transmit/receive
Date:
05-Apr-00
Prepared by:
No.:
RA283001
K. Takagi
Action required
Service manual revision
Retrofit information
Please add the following SP mode in your Adonis-C1 Scanner Kit service manual, on page
4-2.
SP mode No. 017 has been added so that the scanning margin can be adjusted. This was
made available with the release of scanner controller firmware version 4.0.0.
No Function Settings
017 Trimming
Adjusts the scanning margins for both the main and
sub scan directions.
The larger the value, the wider the margin.
0 ~ 5
1 mm / step
0
echnical Bulletin
T
PAGE: 1/1
Model:
Subject:
From:
Adonis-C1 (Scanner Option)
Scanner controller does not connect to a hub
Technical Services Dept., GTS Division
Classification:
Troubleshooting
Mechanical
Paper path
Other ( )
Part information
Electrical
Transmit/receive
Date:
24-Jan-01
Prepared by:
No.:
RA283005
S. Tomoe
Action required
Service manual revision
Retrofit information
SYMPTOM
The scanner controller may not connect with some types of hubs at 10 Mdps, depending
on the particular hub and scanner NIB combination.
CAUSE
The OSC5 oscillator on the scanner controller does not match the particular hub.
SOLUTION
The OSC5 oscillator has been changed. The new controller is A8775311 (A8775310N).
Note: Initially, this was only a suffix change, however later we changed the part number to
A8775311.
Loading...